Download Print this page

Casio DQD-105 Operation Manual

Hide thumbs

Advertisement

Quick Links

MA0702-EA
ILLUSTRATION
5
2
Operation Guide DQD-105
3
4
1
2
1
8
• A sticker is affixed to the glass of this clock when you purchase it. Be sure to remove the sticker before using the clock.
• Depending on its model number, the appearance of your clock may differ somewhat from that shown in the
6
illustration.
Current time (Hour, minutes, seconds)
PM indicator
GENERAL GUIDE
1 SNOOZE/LIGHT button
• Press this button to illuminate the display for about four seconds.
• Pressing this button while the alarm is sounding stops the alarm.
2 WAVE button
Press this button to receive the time calibration signal and adjust timekeeping.
3 AUTO LIGHT button
Use this button to configure Auto Light settings.
4 Alarm Time Set buttons
Use these buttons to change the alarm time or current time setting.
5 SET button
Use this button when setting the current time.
7
6 RESET button
Press this button to reset the clock after replacing its batteries.
7 Alarm Mode selector
SNOOZE: Snooze alarm on
ALM ON: Alarm on
ALM OFF: Alarm off
8 Batteries
Alarm Off
Snooze Alarm On
DST indicator
Snooze on indicator
Antenna Icon
Date
(month – date)
Day of the week
Wave OK indicator
Alarm on indicator
1

Advertisement

loading

  Summary of Contents for Casio DQD-105

  • Page 1 MA0702-EA Operation Guide DQD-105 • A sticker is affixed to the glass of this clock when you purchase it. Be sure to remove the sticker before using the clock. ILLUSTRATION • Depending on its model number, the appearance of your clock may differ somewhat from that shown in the illustration.
  • Page 2 Operation Guide DQD-105 TIME CALIBRATION SIGNAL RECEPTION PRECAUTIONS Unsuccessful Signal Reception The antenna icon disappears from the display when a signal receive operation is unsuccessful. If this happens, • This clock is able to receive the time calibration signal transmitted from try changing the position or orientation of the clock, and press the WAVE button (2) to receive again.
  • Page 3 Operation Guide DQD-105 USING THE ALARM TO TURN AUTO LIGHT ON AND OFF The alarm sounds and the light turns on when the alarm time you set is reached. You can also use the Alarm 1. While the Normal Timekeeping Screen is displayed, press the AUTO LIGHT button (3).
  • Page 4 Operation Guide DQD-105 TO SPECIFY THE ILLUMINATION ON TIME BATTERY REPLACEMENT 1. While the Normal Timekeeping Screen is displayed, press the AUTO LIGHT button (3). Replace batteries whenever the display of the clock becomes dim and difficult to read. 2. Within about five seconds, use the Alarm Time Set buttons (4) to turn on Auto Light.