Advertisement
Table of Contents
LED MIRROR
INSTALLATION MANUAL
AN50, AR50D, GAR70D, GGAR60, G4590D, G60100D, GG45120D, GGG60,
IN4590, IN60100, M75D, M75DB, M90D, M90DB, M120D, M120DB, M150D,
M150DB, M180D, M180DB, ON45, RN9060, RN12075, S60, S60D, S60DB,
S80, S80D, S80DB, SN60, SN80
! CAUTION - This product must be installed by a licensed electrician.
It is the responsibility of the installer to ensure the product is correctly installed, as per
this instruction manual.
Please read this instruction manual & warnings carefully and refer back during
installation to ensure the product is fitted safely and that it retains its high quality.
Page 1/5
Advertisement
Table of Contents
Related Manuals for Remer AN50
Summary of Contents for Remer AN50
- Page 1 LED MIRROR INSTALLATION MANUAL AN50, AR50D, GAR70D, GGAR60, G4590D, G60100D, GG45120D, GGG60, IN4590, IN60100, M75D, M75DB, M90D, M90DB, M120D, M120DB, M150D, M150DB, M180D, M180DB, ON45, RN9060, RN12075, S60, S60D, S60DB, S80, S80D, S80DB, SN60, SN80 ! CAUTION - This product must be installed by a licensed electrician.
-
Page 2: Before Installation
• Always switch off the electrical supply to the product at the mains during installation and maintenance. • Remer mirrors come with a plug, with the preferred installation requiring a recessed plug base or junction box located behind the mirror. -
Page 3: Handling Tips
This installation manual applies to all LED Mirrors ex Eclipse & Kara. Mirror shape for illustrative purposes only. HANDLING TIPS: • Do not place Remer mirrors on hard surfaces. • Always lift with two or more people. • Measure and install bracket on the wall using the appropriate wall fixings for your wall type. -
Page 4: Installation
INSTALLATION INSTALLATION All Remer LED products require an isolation switch as set out in the Australian Electrical Safety Standards with appropriate circuit protection. Install the bracket vertical hole first followed by horizontal hole and middle. Vertical to adjust the height of bracket. Horizontal to ensure the bracket levels. - Page 5 Bluetooth models only excluding Miro: Remove screw caps and screw on the spacer. Please note that the range of the adjustment spacer should not exceed 40mm from the back of the mirror. Screw cap Spacer/Adjusting lever *NOTE: If you plan to have a non-Bluetooth model next to a Bluetooth model, use spacers on both mirrors to ensure an even installation.
- Page 6 VIEW OUR USER & MAINTENANCE GUIDE: REMER PTY LED RESERVES THE RIGHT TO MAKE ANY CHANGES IN PRODUCT CHARACTERISTICS, PACKAGING OR AVAILABILITY AT ANY TIME WITHOUT NOTICE. PLEASE VISIT OUR WEBSITE OR CONTACT OUR MELBOURNE BASED CUSTOMER SERVICE TEAM FOR THE LATEST INFORMATION.
Need help?
Do you have a question about the AN50 and is the answer not in the manual?
Questions and answers