Cisco 7606 User Manual page 19

•
•
•
Note
Place labels on each supervisor engine installed in the chassis as shown in either
Step 3
switch),
Place a tamper evidence label so that one half of the label adheres to the PCMCIA slot and the other
a.
half adheres to the Supervisor Engine 2 faceplate. Any attempt to install or remove a Flash PC card
will damage the tamper seal, which indicates tampering has occurred.
Place a tamper evidence label so that one half of the label adheres to the GBIC transceiver installed
b.
in the supervisor engine 2 network interface uplink port and the other half adheres to the Supervisor
Engine 2 faceplate. Any attempt to remove a GBIC transceiver will damage the tamper seal, which
indicates tampering has occurred.
c. Place a tamper evidence label so that it completely covers an unpopulated network interface uplink
port. Any attempt to install a GBIC transceiver in the network interface uplink port will damage the
tamper seal, which indicates tampering has occurred.
Note
Figure 7
WS-X6K-SUP2-2GE
1
SUPERVISOR2
2
3
4
5
6
7
8
FAN
STATUS
9
o
Catalyst 6509 Switch, Cisco 7606 Router, and Cisco 7609 Router with VPN Services Module Certification Note
OL-6334-01
Place one label so that one half of the label adheres to the right side of the opacity shield and
the other half adheres to the chassis.
For the Catalyst 6509 switch chassis only, place one label so that one half of the label adheres
to the bottom of the opacity shield and the other half adheres to the right side of the chassis.
For the Cisco 7606 router chassis only, place one label so that one half of the label adheres to
the bottom of the opacity shield and the other half adheres to the bottom of the chassis.
The Cisco 7609 router does not have an opacity shield.
Figure 8 (Cisco 7606 router), or
The tamper seal label adhesive completely cures within five minutes.
Catalyst 6509 Switch Chassis Tamper Evidence Label Placement
Switch Load
100%
CONSOLE
PORT PORT 1 PORT 2
CONSOLE MODE
PCMCIA
EJECT
1%
o
INPUT
FAN OUTPUT
OK
OK FAIL
INPUT
FAN OUTPUT
OK
OK FAIL
Figure 9 (Cisco 7609 router).
Physical Security
Figure 7 (Catalyst 6509
19