Cisco 3640 Quick Start Manual page 26

Figure 21 SDM Launch Page
Tip If the SDM Launch page does not appear when you enter the URL https://10.10.10.1/flash/sdm.shtml, test the
connection between the PC and the router by doing the following:
a. Check that the POWER LED on the router is on, and that the ACTIVITY LED is on, indicating an active Ethernet
connection between the router and the PC. If the ACTIVITY LED is not on, verify that you are using a crossover cable
to connect the PC to the router.
b. If the Launch page still does not appear, verify that the web browser's "work offline" option is disabled. In Internet
Explorer, click the File menu, and verify that the "work offline" option is unchecked. In Netscape, the default selection
in the File menu is set to "work online."
c. If the Launch page still does not appear, verify that the file sdm.tar is loaded into the router's Flash memory. Open a
Telnet session to 10.10.10.1, entering the username sdm and the password sdm. Enter the command show flash to verify
that sdm.tar is loaded in Flash memory.
d. If the web page still does not appear, verify that the PC is configured with a static IP address.
Step 5 A window appears with information about the web browser and its settings. This window also informs you that SDM
will open in another window. Close this window and wait for the SDM Startup Wizard page to appear.
Step 6 When the SDM Startup wizard appears, click Next to begin. Use the wizard to give the router a hostname, to assign a
login username and password, to set an enable secret password, and to assign a new LAN IP address to the FastEthernet
interface 0/0. You can also configure the router as a Dynamic Host Configuration Protocol (DHCP) server, identify
Domain Name System (DNS) and Windows Internet Naming Service (WINS) servers, and make security settings.
Tip Be sure to write down the enable secret password. It is not revealed in the summary window and cannot be recovered.
Step 7 When the Summary window appears, write down the LAN IP address, hostname, login username, and user password
that you entered, and click Finish. (You will need this information to reconnect to the router and use SDM to perform
additional configuration.)
Step 8 Assign a new IP address to the PC's Ethernet interface; place it on the same subnet as the router's FastEthernet 0/0 port,
which you assigned in Step 6 above. (See Figure 22.) If you configured a DHCP server on the router, configure the PC
to obtain an IP address automatically. The IP addresses in Figure 22 are examples only.
26