Cisco 12406 Replacement Instructions Manual page 34

Note
Step 2 Verify that the anchor clips and angle brackets fastening the chassis to the shipping pallet base are
installed correctly and that the bolts are tight.
Place the plastic bag over the chassis. (See
Step 3
Step 4 If required, place the accessories package on top of the chassis. (See
Step 5 Set the outer shipping container over the chassis and set it squarely on the shipping pallet base.
(See Figure
Use a strapping machine to wrap two straps side-to-side over the top of the shipping container to secure
Step 6
it to the shipping pallet base.
The chassis is now repackaged and ready to be transported. Use a forklift or pallet jack to move the
repackaged chassis.
Cisco 12006 and Cisco 12406 Router Chassis Replacement Instructions
34
The two anchor clips are used on the bottom holes of the rack-mounting flanges and are bolted
to the shipping pallet base. The angle brackets are fastened to the three-hole NEBS receptacle
on the side of the chassis near the rear panel using three screws and then bolted to the shipping
pallet base.
20.)
Figure 20.)
Figure 20.)
78-16109-01