Ranger RCI-2970 Service Manual

Ranger RCI-2970 Service Manual
Ranger RCI-2970
Documentation Project
CBTricks.com
INTRODUCTION
This section explains the basic programming procedures for the RCI-295012970 amateur 10 meter mobile
transceiver.
FREQUENCY SELECTION
Frequency selection in the RCI-2950/2970 can be accomplished using three of the following methods:
1. The first method of frequency selection is through the use of the
arrows. To accomplish this, press the
the frequency that is to be changed. Then use the
is desired, press the
desired frequency is dispIayed in the LCD display window.
2. The second method of frequency selection is accomplished using the
knob located above the microphone jack. Use the SHF button in the manner described above to select the digit to
be changed. Then proceed to rotate the frequency select knob clockwise to increase the frequency. Rotate the
frequency select knob counterclockwise to decrease the frequency.
3. The third method of selecting the operating frequency of the radio is through the use of the
the channel Up and Down button located on the microphone Frequency selection by this method is accomplished in
the same manner as with the
Up and Down buttons on the microphone are used.
While in receive mode, once a signal has been detected on a particular frequency, it may be necessary to slightly
change the frequency to provide the best audio through the speaker. This can be accomplished by rotating the
http://www.cbtricks.com/radios/rci/rci_2970/rci2970_oper.htm
Click to see close up
arrow. Perform the steps described above for each digit of the frequency until the
and arrows on the key pad. The only difference is that the channel
(Shift) key and the
button until the cursor arrow is positioned under the digit of
arrow to increase the number. If a decrease in frequency
button and the frequency select
10/2/11 8:20 PM
and
button and
Page 1 of 4