The pump is equipped with a 3-prong grounding-type power cord. The ball bearings on the motor shafts never need to be lubricated. Pump only • Motor housing….Die casting aluminum for WSSP3 water with this pump. It is also not engineered to be Cast iron for WSSPC3 •...
CAUTION 6. Secure the pump on a solid base to keep the pump vertical and above mud and sand during operation ● This pump is designed for home sump applications. to maximize pumping efficiency and prevent The pump is equipped with a 3-prong clogging and premature pump failure.
1. Wrap threads of the 1 1/4 in. adapter ( included) PREPARATION with thread tape, then screw the adapter into pump outlet hand tight plus 1 turn with a wrench. WARNING: Always use handle to lift pump. Notice: If the discharge pipe you will connect is 1 1/2 in., Never usepower cord to lift pump.
Page 5
6. Plug the pump into a GFCI outlet. 4. Place the pump in the sump, make sure that nothing interferes with switch operation. Notice: Remove all small stones, gravel, mud, or other debris from the sump pit before installing the pump. The minimum diameter of the sump pit is 14 in.
Do not handle this pump or plug in or unplug this pump water lowers to certain level, the float switch will turns with wet hands or while standing in water, unless you off the pump. are certain all power has been turned off to the pump. 3.
WARRANTY EXCLUSIONS 1. Neither Water Source, LLC, nor the store that sold this pump shall in any event be liable for any labor or similar expenses incurred in removing or repairing this pump.
Need help?
Do you have a question about the WSSP3 and is the answer not in the manual?
Questions and answers