BALCO HE180447 Manual

Using the
phone holder
selfie stand
1. Mounting your phone
holder with selfie light
Using the clip at the end of the
product, carefully clip the phone
holder with selfie light to the edge of a
table, desk or anywhere that the clip
will grip securely
NOTE: You will need to check that you have access
to either a computer or USB power adaptor and
power supply for the selfie light
2. Mount your smartphone
by securing it in the
phone holder
Pull the top section of the phone
holder to extend. Carefully place your
phone between the top and bottom
sections of the holder. Your phone
should be firmly secured
NOTE: You won't need to remove your phone case
3. Lighting mode
Plug the USB into either a power
adaptor (not supplied) or a computer/
laptop (not supplied). Then press the
power button on the control panel.
On the control panel you can adjust
the brightness of the LED selfie light
by pressing the + to increase the
brightness or the – to decrease the
brightness. There are 10 levels for you
to choose from. You can also change
the colour of the white by pressing the
button. There are three whites to
choose from (these range from cold
to warm white)
4. Position the phone
holder with selfie light
at your desired position
and angle
Move the light and the phone holder around until you are happy with the
position of both of these. You can also adjust the angle of the phone holder
5. Once you are happy with the look, simply smile and
start
Aim the mobile and press either the camera image to take a photo or start
recording
1.
2.
*Smartphone not included
3.
HE180447
PLU: 708328
12/2020
Increase
brightness
Change colour
temperature
Decrease
brightness
Power