Table of Contents
Advertisement
TCP/IP
Obtain an IP Address
automatically
(DHCP Client)
Fixed IP Address:
IP Address: Enter a free IP Address from the address range used
Network Mask:
Gateway:
Enable DHCP Server:
Start IP Address: The first value for the range of IP Addresses to be
Finish IP Address: The last value for the range of IP Addresses to be
Microsoft Networking
Workgroup Name:
Enable WINS
WINS Server
If you have a DHCP or Bootp server on your LAN,
you can enable this setting. The Disk Server will then
obtain its IP Address from the DHCP or Bootp server.
However, because this is a Server, it is preferable to
use a Fixed IP Address.
If your LAN does not have a DHCP server, then you
must select Fixed IP Address.
Select this option to enter an IP Address. This option
is required if you wish to use the DHCP Server func-
tion.
by PCs on your LAN. The default Disk Server value is
192.168.0.2
Use the same value as PCs on your LAN. The default
Disk Server value is 255.255.255.0
Use the same value as PCs on your LAN. If you don't
have a router or Internet Gateway, leave this at the
default value (blank).
If checked, the Disk Server will provide an IP Address
and related data to PCs on request. PCs will only make
such as request if they are set to act as DHCP clients.
(See Windows Client Setup and Mac Client Setup for
details.)
allocated by the DHCP Server.
allocated by the DHCP Server
Ensure that the range is large enough for the number
of DHCP clients (PCs and other devices making DHCP
requests.)
Normally, this name should match the Workgroup
name used by PCs on your LAN.
Check this if your LAN has a WINS (Windows Inter-
net Naming Service) Server.
Enter the IP Address of the WINS Server. This is
normally a system running Windows NT Server.
Page 9
Advertisement
Table of Contents
