Installation Instructions - Danby DAC6010E Owner's Use And Care Manual

LOCATION
A) This room air conditioner is designed to fit
easily into a single or double hung window.
However, since window designs vary, it may be
necessary to make some modifications for safe,
proper installation.
B) Make sure window and frame are structurally
sound and free from dry and rotted wood.
C) For maximum efficiency, install the air
conditioner on a side of the house or building
which favours more shade than sunlight. If the unit
is in direct sunlight, it is advisable to provide an
awning over the unit.
D) Provide sufficient clearance around the cabinet to
allow for ample air circulation through the unit
(See Fig. 2). The rear of the unit should be
outdoors and not in a garage nor inside a building.
Keep unit as far away as possible from obstacles/
obstructions and at least 30" above the floor or
ground. Curtains and other objects within a room
should be prevented from blocking the air flow.
Be certain the proper electrical outlet is within reach
INSTALLATION
INSTRUCTIONS
1) Assembly of the Upper Channel to Cabinet.
• "L" Shaped Top Channel: Install the "L" shaped channel to the
top of the cabinet as shown in Fig. 3, using four (4) 3/8" screws.
2) Assembly of the Side Curtains to Cabinet.
• Extend the shutter from the shutter frame and slide it into the
shutter tabs on the side channel of the air conditioner, as shown
in Fig. 4.
• Slide the shutters into the top ("L" Shaped) and bottom ("U"
Shaped) channels. The shutters are identified (on frame) as left
and right.
INSTALLATION
of the installation. Use only a single outlet circuit
rated at 15 amps. All wiring should be in accordance
with local and national electrical codes.
F) DO NOT install unit where leakage of
combustible gas is suspected. Your air conditioner
may fail to operate in air containing oils
(including machine oils), sulfide gas, near hot
springs, etc.
Side
Obstruction
Fig. 2
4
20"
Min
30"
Min
Ground
"U" shaped Channel
Fig. 3
(Factory Installed)
Shutter tabs
Shutter
Shutter frame
Awning
12" Min
20"
Min
Fence,
wall, or
other
obstacle
3/8" screws
"L" shaped
mounting bracket
Fig. 4