Related Manuals for Fresh KTM-25RS1
Summary of Contents for Fresh KTM-25RS1
- Page 1 USER MANUAL TOP MOUNT UPRIGHT ※ Please read this manual completely before attempting to install or operate this equipment https://fresh-refrigeration.com.au...
-
Page 2: Safety Precautions
SAFETY PRECAUTIONS To avoid any risk of fire, explosion, electric shock, personal injury, material damage or incorrect use of the appliance, always observe the following safety precautions. Read the owner’s manual instructions and retain them in safe place for future. Ensure the unit must be installed and located in accordance with the manufacturer’s installation Ensure the unit is disconnected from the power supply before any maintenance... -
Page 3: Before Installation
Bill of Lading followed with a claim to the carrier. As all equipment has been inspected and tested on site at our manufacturing facility, FRESH Refrigeration is NOT RESPONSIBLE for freight loss or damages. -
Page 4: Ambient Temperature
Ambient Temperature The unit is intended to install indoors only to avoid extreme temperature and humid The unit must be installed in an Do not place the unit in an environment within its climate area next to heat generating class. equipment or with direct ( 30 ℃... - Page 5 USAGE Temperature - This unit is NOT for Chilling nor Freezing. Please cool down the hot/warm food or product before storing - Cool down the unit until achieving the desired temperature before loading product or food You must run the unit for 24 hours prior to usage to achieve desired interior temperature Loading Do not store too much product Give 25mm room between...
-
Page 6: Maintenance
MAINTENANCE Interior and Exterior Cleaning - The interior surfaces of the cabinet should be periodically cleaned with a food safe solution such as water and baking soda. All stainless-steel surfaces should be cleaned with commercially approved solutions. - Do not use chlorinated cleaners on the stainless-steel surfaces. - Do not use stainless steel cleaners or other solvent-based chemicals on the plastic parts (door handle or trim strips) as they can cause corrosion. -
Page 7: Specifications
SPECIFICATIONS - Above specifications are subjected to change without prior notice for quality improvement. - The height includes 3-inch casters. 4- or 5-inch casters are available... -
Page 8: Basic Operation
OPERATION Basic Operation Plug in and the unit is automatically turned on. The display panel will be lighted with beep sound and begin it’s operation after 5 seconds. The compressor will begin to run. The default temperature setting is 4 ° C for fridges and -18 ° C for freezers. The compressor and defrost cycle are automatically programmed by the electronic controller (PCB). -
Page 9: Call For Service
Temperature Control Button - Use the button to change the temperature. - By pushing the up / down button, you can set the cabinet inner temperature. - Leave it without any further operation for 3 seconds, the temperature setting is done, and the lamp will turn off. - Page 10 TROUBLE SHOOTING The Following points are not malfunctions: Water-Flowing sound when the compressor stops : this sound is refrigerant flowing The compressor stops when defrost cycle...
-
Page 11: Warranty Information
WARRANTY INFORMATION Limitations Fresh Refrigeration’s sole obligation under this warranty is limited to either repair or replacement of parts, subject to the additional limitations below. This warranty neither assumes nor authorizes any person to assume obligations other than those expressly covered by this warranty. - Page 12 Warranty for Goods (from T&C) 12.2.1 Unless otherwise stated in our quotation or agreed by us at the time of acceptance of your offer, subject to 12.4.2, the warranty period for the supply of goods shall be one year from the date of manufacture of the goods (Goods Warranty Period).
Need help?
Do you have a question about the KTM-25RS1 and is the answer not in the manual?
Questions and answers