Table of Contents
Advertisement
Quick Links
O U T D O O R W A l l B R A C K E T
This guide has been created to give the end-user a simple and efficient way to install the EG4 Mini-Split
outdoor wall bracket.
©2024 EG4 ELECTRONICS, LLC. ALL RIGHTS RESERVED.
VERSION 1.0.1 | INFORMATION IS SUBJECT TO CHANGE WITHOUT NOTICE.
MODEL#: APAB-3160
E G 4 ® M I N I - S P L I T
Q U I C K S T A R T G U I D E
Advertisement
Table of Contents
Related Manuals for EG4 MINI-SPLIT 1611001
Summary of Contents for EG4 MINI-SPLIT 1611001
- Page 1 O U T D O O R W A l l B R A C K E T Q U I C K S T A R T G U I D E This guide has been created to give the end-user a simple and efficient way to install the EG4 Mini-Split outdoor wall bracket.
-
Page 2: Table Of Contents
TABLE OF CONTENTS OVERVIEW ................................1 RECOMMENDED TOOLS ............................. 1 PACKING LIST................................ 1 INSTALLATION STEPS ............................2 IDENTIFY THE INSTALLATION LOCATION .................... 2 CHECK WALL STRENGTH ......................... 3 INSTALL THE CROSSBAR ......................... 3 PREPARE THE BRACKETS........................4 ATTACH THE BRACKETS .......................... 4 INSTALL OUTDOOR UNIT ON BRACKETS ..................... -
Page 3: Overview
1. OVERVIEW The EG4 Mini-Split outdoor wall mount bracket has been made to withstand a maximum weight of 352 lbs. and supports all EG4 outdoor units. The bracket is made of powder-coated metal to withstand extreme weather keeping the outdoor unit off the ground and protected from ground threats, such as snow or rodents. -
Page 4: Installation Steps
Take into account adequate height above the ground to prevent contact with external elements like water, snow, mud, and debris. The following installation guidelines meet the installation requirements for EG4 Mini-Split outdoor units: Meets all spatial requirements shown in Installation Space Requirements •... -
Page 5: Check Wall Strength
4.2 CHECK WALL STRENGTH Verify that the chosen wall can adequately support the weight of the unit. Ensure it is structurally sound. When mounting the wall bracket on concrete or brick, use the included wall anchors. When mounting the bracket on other substrates (i.e. wood, vinyl, hardy board, stucco, etc), locate wall studs to support the weight of the bracket and outdoor unit. -
Page 6: Prepare The Brackets
Measure the distance between the base feet of the Condensing Unit. The measurements for the outdoor units are listed below. 21.2 in. (539mm) EG4 9K and 12K BTU Units 12.9 in. (327mm) 25.0 in. (635mm) -
Page 7: Install Outdoor Unit On Brackets
d. Set the distance between the brackets to match the distance between the feet of the outdoor unit (measurement A). The distance between the brackets should be verified from center hole to center hole as shown below. e. If needed, attach additional wall anchors or screws (circled above) into the vertical brackets to support the required load capacity. - Page 8 CONTACT US support@eg4electronics.com (903) 609-1988 www.eg4electronics.com...
Need help?
Do you have a question about the MINI-SPLIT 1611001 and is the answer not in the manual?
Questions and answers