Subscribe to Our Youtube Channel
Related Manuals for Friax Vintage EVX2
Summary of Contents for Friax Vintage EVX2
- Page 1 Installation manual SPCH-EVX2-WEVX2 Vintage "FRIAX industrie", in a constant endeavour to improve its products reserves the right to change any information contained in this leaflet without prior warning. EN-NT-SPCH-EVX2-0523...
- Page 2 Avertissement Warning Ce symbole indique que le manuel d’installation doit être lu attentivement. This symbol indicates that the installation manual should be read carefully. Ce symbole indique qu’un technicien de service doit manipuler cet équipement en se référant au manuel d’installation. This symbol indicates that a service technician should handle this equipment in referring to the installation manual.
- Page 3 EVX2 Vintage EVX2 Vintage We invite you to examine the package upon receipt for any damage to the boxes or missing items. Please note event of damage observed during the unpacking. -1 x Outdoor unit. -1 x Indoor unit and its body -1 x Glossy Galaxy Black Front Dimensions without palett: -1 x Bag of accessories and connectors.
-
Page 4: Maintenance
EVX2 Vintage 1.Technical data and dimensions 6-7-8 9-12 13-14 5. Electrical connections 15-16 6.Close the device-Warning 7. Waste treatment 8.Maintenance EVX2 Genesis-Vintage No insulation Medium insulation Good insulation* VOLUME (m3) *Insulation walls and ceiling 12°C Model 30 Model 48 between 60/80 mm of polyurethane 32°C ext. - Page 5 EVX2 Vintage R134A T cave= +12°C - Text= 32°C SPC EVX2 Unité extérieur SPC… 1100 Voltage 50Hz 230 V/1+T 230 V1+T 1100 1250 Air flow m3/h Absorbed intensity of the AIR / 3.4 / 2.4 4.3 / 3.3 Water group 5.6 / 3.87 6.5 / 3.87 Amax...
- Page 6 EVX2 Vintage Butterfly screw ground. Seen from inside the Butterfly screw Black front...
- Page 7 Level For connection from the rear : The two refrigeration connections and the two electrical connections must pass through Ø70mm this orifice. The partition will have to be drilled. Rear connection hole Connection of refrigeration connections: Connections from the rear the condensate outside the cellar.
- Page 8 Cellar probe Evaporator-group Condensor probe back cellar Evaporator Cellar side Friax control box Condensate recovery tray KPR-XJ Pressure relief kit...
- Page 9 EVX2 3.Installation of outdoor unit to AIR 30-48 (GCH) Vintage 3.1 Dimensions 2 x Ø11 4 x Ø9 2 x Ø6 ~116°...
-
Page 10: Wall Mounting
Advice - -Favor open places, sheltered from the sun. -Elevate the group to avoid leaves and snow - Check the solidity of the supports. -Beware of noise for the neighborhood 3.2 Wall mounting Installation with the KS2M kit (list of accessories) 133 mm 100 mm 100 mm... -
Page 11: Fixing To The Floor
3.3 Fixing to the floor The GCH group can be placed on the ground using Rubber Foot (not supplied and not sold by Friax) to avoid operating vibrations. 3.4 Cover disassembly 1-Using a screwdriver take out the nail 2-Slide the cover in the direction of the arrow rubber blocker.. - Page 12 EVX2 Installation of the water condensation unit 30-48 Genesis-Vintage 3.5 Dimensions A installer hors-gel To set in frost-protection The water groups are made for installation in a room above 0°C. BNS = 25 Compressor fan 3.6 Fastening system Plug & Lock The installation of the Low sound level kit must be done before fixing the outdoor unit.
- Page 13 EVX2 Vintage Prendre soin de bien lire ceci avant d’installer votre matériel FRIAX si le groupe extérieur est au-dessus de l’évaporateur Take care of reading this before installing your FRIAX-s equipment if the condensing unit is over the evapo- rator.
- Page 14 Effectuer le raccordement à la Make the connection to the pipe Die Verbindung im Rohrnetz fitting (flare connections). tuyauterie (raccords flare). ausführen (Schnittstellen flare). Après avoir raccordé, tirer au vide la Nach dem Anschluss, ziehen Sie den After connecting, pull the vacuum tuyauterie et l'évaporateur par l'inter- Vakuum-Leitungen und der Verdam- piping and the evaporator through...
- Page 15 EVX2 Vintage 3 connectors are delivered to you in a bag in the evaporator box, for be connected to your cables following the assembly below.. 1. Stripping length = 30 mm (2 poles), 37 mm (3 poles), 45 mm (4 and 5 poles) 2.
- Page 16 Connector (F) lift pump connector (F) LED RJ 12 POWER SHGR SUPPLY 1 2 3 4 3 2 T 1 4 3 2 T 1 Not provided Not provided Not provided Not provided Sonde condenseur Condensor probe R=10V Kondensatorsonde J=PWM B=GND BL=TAC Résistance carter...
- Page 17 To avoid any risk of injury or material body. this body to check that your hydraulic Do not try to dismantle the system yourself: dismantling the system as well as processing the refrigerant, oil and other components must be performed by a qualified installer, in accordance with applicable local and national regulations.
- Page 18 EVX2 Vintage rants. place. - Close the device.
- Page 20 Expert Français du vin www.friax.fr Découvrez notre gamme de rangement pour la cave ! www.visiorack.com...
Need help?
Do you have a question about the Vintage EVX2 and is the answer not in the manual?
Questions and answers