Related Manuals for Ferroli GS 12 OE BIPTG
Summary of Contents for Ferroli GS 12 OE BIPTG
- Page 1 DIGITAL I ( ) I ( ) I ( ) I ( ) CASA (S) PTE.LTD. 15 Kian Teck Crescent Singapore 628884 Hot line: 62680077 Email: Service@casa.com.sg...
- Page 3 Remote controller size: 140mm （ L ） x 115mm （ W ） S et k ey In standby state, press SET key for 3s to set the time for backlight protection. The ● default value is 30s and can be regulated by UP and DOWN keys to set the time for backlight screen protection.
- Page 4 Water output temperature display(for example 50 ) ℃ Fault code display quantitative water release of bath display bathtub indicator in use Time setting of timed preheating ●In standby state, press Timer key for 3s to enter the setting of timing interval T1 and T2. After entering thesetting, press Timer key to choose the corresponding hour and minute, press UP/DOWN key to change the value of hour and minute.
-
Page 5: Installation Requirement
Installation Requirement Installation Requirements 1. Installation and maintenance shall be conducted by qualified professional personnel in accordance with the existing regulations and the manufacturer’s instructions. 2. Wrong installation or improper maintenance will cause damage to human or animals or damage of property. The manufacturer won’t assume any responsibility for the loss caused by wrong installation or use or noncompliance with the manufacturer’s instructions. - Page 6 Pipe Connection Outdoor model installation 1. Before installation, please check and clean all For outdoor model, in the range around the exhaust hole (600mm to the front, 300mm to the gas pipelines and water pipelines to remove top, 150mm to the bottom and 150mm to both sides), there must not be any window which is any residue that may influence operation of the open to indoor.
- Page 7 V II After the system is power up, the buzzer will buzz once, the full LCD screen will be on, and then off after "00" is shown. The indicator light of On/Off key will be always on. The panel will show "OF" and actual-time clock. At the moment, the system is in OFF mode. To turn on the water heater, press On/Off key, if the system doesn’t detect any fault signal, LCD will show the set temperature, actual-time clock and priority icons.
- Page 8 VIII...
- Page 9 (20L indoor model) (with 13A approved plug) Water temperature is 559x378x146mm 599x442x146mm over 90℃ last for 10s Communication error Please contact the service center...
Need help?
Do you have a question about the GS 12 OE BIPTG and is the answer not in the manual?
Questions and answers