1. Manuals
  2. Brands
  3. ATIGO Manuals
  4. Receiver
  5. A1004
  6. User manual

ATIGO A1004 User Manual

2-wire audio receiver
Hide thumbs
1
2
3
4
5

Advertisement

Table of Contents

A1004
2-Wire Audio Receiver
User Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the A1004 and is the answer not in the manual?

Questions and answers

Related Manuals for ATIGO A1004

Summary of Contents for ATIGO A1004

  • Page 1 A1004 2-Wire Audio Receiver User Manual...
  • Page 2 Contents Audio Receiver A1004 ................3 System Layout ..................3 Installation Setup ..................4 Setup Call Address ................. 4 Listening Mode: ................... 4 Setup Master / Slave settings ..............4 Key setup ..................... 4 Calling test ..................... 4 User Personalisation Setup ............... 4 Ring tone volume ...................

  • Page 3: System Layout

    Audio Receiver A1004 System Layout With only A1004. No Video monitors Mixed A1004 with Video monitor. Distributor is necessary for mixed systems...

  • Page 4: Installation Setup

    Listening Mode: • Connect A1004 and door station to the Calling test power supply and then power on. After setup, the A1004 can initiate a call to the • Set A1004 to Listening mode, by door station. pressing and holding for 6s until LED flashes then release.

  • Page 5: Restoring Factory Settings

    ATIGO standard door station. Restoring Factory Settings Restore the handset to factory settings by following these steps: • Disconnect the A1004 from bus line, wait for 30s, and re-conect. • Within 10s after power up, press and hold for 12s, release when LEDs flash.

Table of Contents