Related Manuals for THORLABS GPS011-EC
Summary of Contents for THORLABS GPS011-EC
- Page 1 GPS011 - EC GPS011 - US GPS011 - JP Galvo Scanner System Linear Power Supply User Guide...
-
Page 2: Table Of Contents
Galvo Scanner System Linear Power Supply Table of Contents Chapter 1 Overview ......................1 Chapter 2 Safety Information ..................... 2 Chapter 3 Installation and Operation ................3 Chapter 4 Specifications..................... 6 Chapter 5 Certifications and Compliance ................ 7 Chapter 6 Thorlabs Worldwide Contacts ................. 8... -
Page 3: Chapter 1 Overview
Galvo Scanner System Linear Power Supply Chapter 1: Overview Chapter 1 Overview The GPS011 power supplies are low noise, linear supplies designed to minimize electrical interference for maximum system resolution when using our Galvo Scanning Systems. The supplies allow two driver cards to be powered via the separate 2 m power cables supplied with the galvo units. -
Page 4: Chapter 2 Safety Information
Galvo Scanner System Linear Power Supply Chapter 2: Safety Information Chapter 2 Safety Information For the continuing safety of the operators of this equipment, and the protection of the equipment itself, the operator should take note of the Warnings, Cautions and Notes throughout this handbook and, where visible, on the product itself. -
Page 5: Chapter 3 Installation And Operation
Galvo Scanner System Linear Power Supply Chapter 3: Installation and Operation Chapter 3 Installation and Operation Environmental Conditions Warning Operation outside the following environmental limits may adversely affect operator safety. The unit is designed for indoor use only. To ensure reliable operation, the unit should not be exposed to corrosive agents or excessive moisture, heat or dust. - Page 6 Galvo Scanner System Linear Power Supply Chapter 3: Installation and Operation 3. Push the 3-way crimp housing on the other end of the cable into the driver card connector J10. Ensure the connector is properly locked in position. Figure 2 J10 power Connector Pin Identification 4.
- Page 7 Galvo Scanner System Linear Power Supply Chapter 3: Installation and Operation 3. Plug the power cord into the wall socket. Figure 4 Rear Panel JP Models Using the Power Supply Unit 1. Make connections and voltage selection settings as detailed in section 3.2 and section 3.3. —...
-
Page 8: Chapter 4 Specifications
Galvo Scanner System Linear Power Supply Chapter 4: Specifications Chapter 4 Specifications Parameter # Value Switchable as follows: 100 VAC 50 or 60 Hz Input Voltage Range 115 VAC 60 Hz 230 VAC 50 Hz ±15 VDC 3.0 A/0.1A, 1.4/6.3 ms Output Voltage (Maximum Duty Cycle) Input Voltage Dependent:... -
Page 9: Chapter 5 Certifications And Compliance
Galvo Scanner System Linear Power Supply Chapter 5: Certifications and Compliance Chapter 5 Certifications and Compliance Rev. F, May 21, 2024 Page 7... -
Page 10: Chapter 6 Thorlabs Worldwide Contacts
Galvo Scanner System Linear Power Supply Chapter 6: Thorlabs Worldwide Contacts Chapter 6 Thorlabs Worldwide Contacts For technical support or sales inquiries, please visit us at for our most up-to-date www.thorlabs.com/contact contact information. USA, Canada, and South America UK and Ireland Thorlabs, Inc. - Page 11 www.thorlabs.com...
Need help?
Do you have a question about the GPS011-EC and is the answer not in the manual?
Questions and answers