Advertisement
Quick Links
Light alarm system Cabinet guard
After completion, the OPITEC work kits are not articles with toy character of a ge-
nerally commercial kind, but teaching and learning aids to support educational
work. This kit may only be built and operated by children and young people under
the guidance and supervision of competent adults. Not suitable for children under
36 months. Danger of suffocation!
Parts list
Plywood
Acrylic glass
Acrylic glass
Acrylic glass
Strip grid
Resistor 1.8 kOhm (brown,grey,red)
Resistor 18 kOhm (brown,grey,orange)
Photoconductive cell oval
Mini buzzer rectangular
NPN transistor BC 547
Micro slide switch
Battery clip
Pan head cross recessed sheet metal screw
1
Note
Number of pieces
1
1
1
1
1
1
1
1
1
1
1
1
1
105.107
Tools required:
Ruler
Pencil
Countersink
Dimensions (mm)
73x53x8
110x30x3
161x30x3
80x60x3
40x25x2,54
19x6
ø2
ø6
Drill
Sandpaper
Side-
wire stripper
cutter
Pen
Fretsaw
(waterproof)
Description
Base plate
Housing
Housing
Housing
Circuit board
Resistor R1
Resistor R2
Photoconductive cell
Mini buzzer
Transistor
Switch
Connection battery
Fastening
Phillips screwdri-
ver
Soldering iron
and tin
Superglue
Part no.
1
2
3
4
5
6
7
8
9
10
11
12
13
Advertisement
Related Manuals for Opitec 105.107
Summary of Contents for Opitec 105.107
- Page 1 Note After completion, the OPITEC work kits are not articles with toy character of a ge- nerally commercial kind, but teaching and learning aids to support educational work. This kit may only be built and operated by children and young people under the guidance and supervision of competent adults.
- Page 2 Building instruction 105.107 Light alarm system Cabinet guard Fasten the circuit board to the base plate here! Connection photoresistor Connection red cable battery clip Connection black Connection red cable cable for switch mini buzzer Connection black Connection red cable mini buzzer...
- Page 3 Building instruction 105.107 Light alarm system Cabinet guard Cut the battery clip leads (12) in half. Strip all ends about 5mm. The Solder the battery clip wires (12) to connector (C14-red) and connector separated pieces of cable are used to connect the switch.
- Page 4 Building instruction 105.107 Light alarm system Cabinet guard ø6 Mark the holes on the acrylic glass (4) using the template (page 5). Glue the cover to the frame. After the glue has dried, round off the Then drill the holes carefully with a suitable drill and some water/oil.
- Page 5 Building instruction 105.107 Light alarm system Cabinet guard Template acrylic glass cuts M 1:1...
- Page 6 Building instruction 105.107 Light alarm system Cabinet guard...
- Page 7 Building instruction 105.107 Light alarm system Cabinet guard Drilling template base plate M 1:1...
Need help?
Do you have a question about the 105.107 and is the answer not in the manual?
Questions and answers