Dell PowerEdge 1855 Configuration Manual page 10

Figure 1-3. KVM Module Basic Configuration
monitor
keyboard
mouse
system
4 If required, configure the hard drives for RAID 1 or integrated mirroring. It is recommended
that you configure RAID 1 prior to installation of the operating system. See "Configuring
Drive Mirroring With PERC 4/im Integrated RAID" for more information.
NOTE:
is already configured.
5 If required, set up console redirection on the server module to either the BMC or to the
DRAC/MC module serial port in the server module System Setup program. See "Enabling
and Configuring the DRAC/MC to Use a Serial or Telnet Console."
NOTICE:
mask, and gateway to the BMC before connecting to the network. The assigned static BMC address
must match the LOM_1 address of one of the server modules. For more information on configuring and
using the BMC, see "Assigning a Static Address to the BMC."
8
General System Configuration
If you ordered your server module configured for RAID 1 from Dell, then your server module
To prevent possible network disruptions, ensure that you assign a static IP address, IP subnet
KVM
module
custom KVM
cable