Table of Contents
Advertisement
Quick Links
VBX-160 CUSTOMER
PRE-INSTALLATION GUIDE
DOCUMENT #D10010
REVISION: A
AUGUST 2018
All rights reserved. No patent liability is assumed with respect to the use of the information contained herein. VersaBuilt Robotics strives constantly to
improve our high-quality products, the information contained in this document is subject to change without notice. VersaBuilt Robotics assumes no
responsibility for errors or omissions, and we assume no liability for damages resulting from the use of the information contained in this publication.
If you need additional assistance please email us at helpdesk@versabuilt.com or call 208.629.5914.
www.versabuilt.com
©VersaBuilt Robotics
Advertisement
Table of Contents
Related Manuals for VersaBuilt VBX-160
Summary of Contents for VersaBuilt VBX-160
- Page 1 AUGUST 2018 All rights reserved. No patent liability is assumed with respect to the use of the information contained herein. VersaBuilt Robotics strives constantly to improve our high-quality products, the information contained in this document is subject to change without notice. VersaBuilt Robotics assumes no responsibility for errors or omissions, and we assume no liability for damages resulting from the use of the information contained in this publication.
-
Page 2: Table Of Contents
VersaBuilt Robotics VBXC/CNC Door Interlock Information ................8 Table of Figures 1 - VBX-160 Pivoted from CNC ...........................2 2 - Top View of VBX-160 in Front of CNC ......................3 3 - Top View of VBX-160 Pivoted Away From CNC ....................3 4 - Gate & Pivot Posts ............................4 5 - Robot Controller Shown on Both Sides of CNC .....................4... -
Page 3: Summary
3. Delivery and installation of your tool will be scheduled by VersaBuilt Robotics and/or your dealer after entry of your order. 4. If, after reading the guide, you have any questions or you are unsure of what is required contact VersaBuilt Robotics for clarification. -
Page 4: Vbx-160 Placement
VBX-160 Placement Ensure that there is adequate space in front of your CNC to locate your VBX-160 and space to pivot the VBX-160 away from the CNC for access to both the VBX-160 and your CNC machine. The following images show the VBX-160 pivoted away and engaged with the CNC. - Page 5 FIGURE 2. TOP VIEW OF VBX-160 IN FRONT OF CNC Use caution when moving or pivoting the VBX-160. Risks to personnel may include severe bodily injury. Pay particular attention when pivoting the VBX-160 to prevent pinching between the VBX-160, your CNC machine and other objects in the vicinity.
-
Page 6: Gate And Pivot Posts
Four (4) holes are drilled into the concrete for each post, with .-13 UNC drop-in concrete anchors inserted into the holes for attaching the posts to the floor. The Gate and Pivot Posts attach to the VBX-160 via steel quick-release pins. -
Page 7: Robot Controller Placement
This unit is 40” wide x 26” deep x 61” tall. It is typically located on either side of the CNC which gives it access to both the VBX-160 cell and the CNC the system is tending. It can be located just about anywhere less than 5 meters (16.4-feet) from the system. -
Page 8: Air Supply Requirements
The VBX-160 has a safety circuit that connects sensors on the rack 1 door, rack 2 door and the gate post where the VBX-160 can be pivoted away from the CNC. If any of these sensors are interrupted, the ‘motors on’...
Need help?
Do you have a question about the VBX-160 and is the answer not in the manual?
Questions and answers