Related Manuals for Sentera Controls RCTHX-2
Summary of Contents for Sentera Controls RCTHX-2
- Page 1 RCTHX-2 INTELLIGENT TEMPERATURE AND HUMIDITY ROOM SENSOR Mounting and operating instructions...
-
Page 2: Table Of Contents
OPERATIONAL DIAGRAMS WIRING AND CONNECTIONS MOUNTING & OPERATING INSTRUCTIONS IN STEPS OPERATING INSTRUCTIONS VERIFICATION OF INSTALLATION INSTRUCTION TRANSPORT AND STORAGE WARRANTY AND RESTRICTIONS MAINTENANCE MIW-RCTHX-2-EN-000 - 19 / 07 / 2024 2 - 9 www.sentera.eu back to the table of contents... -
Page 3: Safety And Precautions
If you have any further questions, please contact your technical support or consult a professional. MIW-RCTHX-2-EN-000 - 19 / 07 / 2024 3 - 9 www.sentera.eu back to the table of contents... -
Page 4: Product Description
AND HUMIDITY ROOM SENSOR PRODUCT DESCRIPTION The RCTHX-2 are intelligent room sensors featuring adjustable temperature and relative humidity ranges. The used algorithm controls a single analogue / modulating output based on the measured temperature and humidity values, which can be used to directly control an EC fan, an AC fan speed controller or an actuator powered damper. -
Page 5: Operational Diagrams
Minimum Maximum Maximum Minimum Output [%] range alert alert range T [°C] / rH [%]* LED indications - T (default) or rH MIW-RCTHX-2-EN-000 - 19 / 07 / 2024 5 - 9 www.sentera.eu back to the table of contents... -
Page 6: Wiring And Connections
Using suitable fastening materials (not supplied), position the room sensor at least 1,5 m from the floor. Mind the correct mounting position and unit dimensions (see Fig. 2 and Fig. 3). MIW-RCTHX-2-EN-000 - 19 / 07 / 2024 6 - 9 www.sentera.eu... - Page 7 Customise the factory settings to the desired ones via the 3SModbus software or Sensistant (if necessary). For the default factory settings see the Modbus register map of the product. MIW-RCTHX-2-EN-000 - 19 / 07 / 2024 7 - 9 www.sentera.eu...
-
Page 8: Operating Instructions
NO T E When the sensor is in bootloader mode, the green and yellow LEDs flash alternately. During the firmware download, the red LED is flashing additionally. MIW-RCTHX-2-EN-000 - 19 / 07 / 2024 8 - 9 www.sentera.eu back to the table of contents... -
Page 9: Verification Of Installation Instruction
In case of heavy pollution, clean with a non-aggressive product. In these circumstances the unit should be disconnected from the supply. Pay attention that no fluids enter the unit. Only reconnect it to the supply when it is completely dry. MIW-RCTHX-2-EN-000 - 19 / 07 / 2024 9 - 9 www.sentera.eu...
Need help?
Do you have a question about the RCTHX-2 and is the answer not in the manual?
Questions and answers