Sentera Controls RCMFM-3 Mounting And Operating Instructions

Intelligent co2 room sensor, power over modbus

Advertisement

Quick Links

RCMFM-3
INTELLIGENT CO
ROOM
2
SENSOR, POWER OVER
MODBUS
Mounting and operating instructions

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RCMFM-3 and is the answer not in the manual?

Questions and answers

Summary of Contents for Sentera Controls RCMFM-3

  • Page 1 RCMFM-3 INTELLIGENT CO ROOM SENSOR, POWER OVER MODBUS Mounting and operating instructions...
  • Page 2: Table Of Contents

    ARTICLE CODE INTENDED AREA OF USE TECHNICAL DATA STANDARDS OPERATIONAL DIAGRAMS WIRING AND CONNECTIONS MOUNTING INSTRUCTIONS IN STEPS OPERATING INSTRUCTIONS VERIFICATION OF INSTALLATION TRANSPORT AND STORAGE WARRANTY AND RESTRICTIONS MAINTENANCE MIW-RCMFM-3-EN-000 - 12 / 03 / 2024 2 - 7 www.sentera.eu...
  • Page 3: Safety And Precautions

    If you have any further questions, please contact your technical support or consult a professional. MIW-RCMFM-3-EN-000 - 12 / 03 / 2024 3 - 7 www.sentera.eu back to the table of contents...
  • Page 4: Product Description

    INTELLIGENT CO ROOM SENSOR, POWER OVER MODBUS PRODUCT DESCRIPTION The RCMFM-3 are intelligent room sensors featuring adjustable CO , temperature, and relative humidity ranges. The used algorithm generates an output value based on the measured T, rH and CO values, which can be used to directly control an EC fan, an AC fan speed controller or and actuator powered damper.
  • Page 5: Operational Diagrams

    Modbus RTU communication, signal /B Pin 6 Pin 7 Ground, supply voltage Pin 8 8 mm 8 mm 8 mm 8 mm 24 VDC MIW-RCMFM-3-EN-000 - 12 / 03 / 2024 5 - 7 www.sentera.eu back to the table of contents...
  • Page 6: Mounting Instructions In Steps

    (not included). Mind the correct mounting position and unit dimensions. See Fig. 2 and Fig. 3. Fig. 1 Snap-fits release Fig. 2 Mounting dimensions 59,8 104,5 104,5 MIW-RCMFM-3-EN-000 - 12 / 03 / 2024 6 - 7 www.sentera.eu back to the table of contents...
  • Page 7 Do the wiring according to the wiring diagram (see Fig. 4). Fig. 4 Wiring Snap the cover back in place. Switch on the mains supply. MIW-RCMFM-3-EN-000 - 12 / 03 / 2024 7 - 7 www.sentera.eu back to the table of contents...
  • Page 8: Operating Instructions

    CO value is higher than or equal to Alert 1 level (Fig. 5 - 2). MIW-RCMFM-3-EN-000 - 12 / 03 / 2024 8 - 10 www.sentera.eu back to the table of contents...
  • Page 9: Verification Of Installation

    Any alterations or adjustments to the product absolve the manufacturer of all liability. The manufacturer disclaims all liability for typographical or other errors in this document. MIW-RCMFM-3-EN-000 - 12 / 03 / 2024 9 - 10 www.sentera.eu...
  • Page 10: Maintenance

    In case of heavy pollution, clean with a non-aggressive product. In these circumstances the unit should be disconnected from the supply. Pay attention that no fluids enter the unit. Only reconnect it to the supply when it is completely dry. MIW-RCMFM-3-EN-000 - 12 / 03 / 2024 10 - 10 www.sentera.eu...

Table of Contents