Connecting And Disconnecting Drive Cables; Hard Drives - Dell Vostro 200 Owner's Manual

1 interface cable

Connecting and Disconnecting Drive Cables

When connecting and disconnecting a serial ATA data cable, disconnect the
cable using the pull-tab.
The serial ATA interface connectors are keyed for correct insertion; that is, a
notch or a missing pin on one connector matches a tab or a filled-in hole on
the other connector.

Hard Drives

CAUTION:
safety instructions in the Product Information Guide.
CAUTION:
the electrical outlet before removing the cover.
NOTICE:
the drive on a surface, such as a foam pad, that will sufficiently cushion it.
NOTICE:
back up your files before you begin this procedure.
Check the documentation for the drive to verify that it is configured for your
computer.
128
Removing and Installing Parts
1
2
Before you begin any of the procedures in this section, follow the
To guard against electrical shock, always unplug your computer from
To avoid damage to the drive, do not set it on a hard surface. Instead, set
If you are replacing a hard drive that contains data you want to keep,
2 interface connector