D-Link DWL-2700AP Manual page 109

DWL-2700AP User's Manual
2. The wireless client cannot access the Internet in the Infrastructure mode.
Make sure the wireless client is associated and joined with the correct access point. To
check this connection: Right-click on the Local Area Connection icon in the taskbar>
select View Available Wireless Networks.The Connect to Wireless Network screen
will appear. Please make sure you have selected the correct available network, as
shown in the illustrations below.
Check that the IP address assigned to the wireless adapter is within the same

IP address range as the access point and gateway. Since the DWL-2700AP has
an IP address of 192.168.0.50, wireless adapters must have an IP address in the
same range, e.g., 192.168.0.x. Each device must have a unique IP address; no two
devices may have the same IP address. The subnet mask must be the same for all
the computers on the network.) To check the IP address assigned to the wireless
adapter, double-click on the Local Area Connection icon in the taskbar > select
the Support tab and the IP address will be displayed. Please refer to Checking
the IP Address in the Networking Basics section of this manual.)
If it is necessary to assign a Static IP Address to the wireless adapter, please refer

to the appropriate section in Networking Basics. If you are entering a DNS Server
address you must also enter the Default Gateway Address. (Remember that if
you have a DHCP-capable router, you will not need to assign a static IP address.
See Networking Basics: Assigning a Static IP Address.)
D-Link Systems, Inc.
Troubleshooting
109