Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Logiquip eLock
Summary of Contents for Logiquip eLock
- Page 1 USER GUIDE eLock KEYLESS ENTRY Read and understand all of the instructions and safety CAUTION information in this document before operating this product. SAVE THESE INSTRUCTIONS (800) 665-3760 www.logiquip.com customerexperience@logiquip.net...
-
Page 2: Table Of Contents
USER GUIDE TABLE OF CONTENTS CARE & CLEANING eLOCK POWERING UP & BATTERY INSTALLATION PROGRAMMING INTRODUCTION UNLOCKING & LOCKING eLock PROGRAMMING MODE CHANGING USER CODE CHANGING SUPERVISOR CODE PROGRAMMING SINGLE USE MODE / STANDARD MODE PROGRAMMING SINGLE USE TIMEOUT ON / SINGLE USE TIMEOUT OFF PROGRAMMING SECURITY TIMEOUT ON / SECURITY TIMEOUT OFF TECHNICIAN MODE –... -
Page 3: Care & Cleaning Elock
Please use high quality alkaline batteries for longest battery life CARE & CLEANING To clean the eLock surface, apply non-acid based cleaner to a clean cotton cloth; do not spray cleaner directly on the eLock Wipe down keypad and its respective housing surfaces of excess cleaner... -
Page 4: Powering Up & Battery Installation
Mixing batteries of different chemistries could damage the eLock resulting in lock failure. ogramming mode (see page 9). s ENTER. To power up the eLock simply, remove the red tag. The eLock is now ready for use. e deleted and press ENTER. be deleted and press ENTER. -
Page 5: Unlocking & Locking Elock
Once in programming mode, multiple changes can be made prior to exiting programming There is a 10-second programming time limit between each step If eLock times out or an error is made, the programming will end and you will need to enter programming mode again... -
Page 6: Changing Supervisor Code
location... -
Page 7: Programming Single Use Timeout On / Single Use Timeout Off
To change the eLock to Single Use Timeout ON or OFF, follow the steps on page 5 to enter programming mode There is a 10-second programming time limit between each step If eLock times out or an error is made,... -
Page 8: Technician Mode - Programming & Operation (Unlock)
3 To relock & retain the single use code that already exists; rotate the knob 90° counter clockwise 4 To remove the existing single use code and leave the eLock unlocked, type the Technician Code and press ENTER 5 Press 1 then press and hold CLEAR for 3-seconds... -
Page 9: Add User To Specific Memory Slot (03 - 20)
User Codes must be 4 to 8 digits in length and must be different from all existing codes (including Slot 01 Supervisor and Slot 02 User Codes) There is a 10-second programming time limit between each step If eLock times out or an error is made, programming will end and you will need to enter programming mode again... -
Page 10: Delete User To Specific Memory Slot (03 - 20)
User Codes must be 4 to 8 digits in length and must be different from all existing codes (including Slot 01 Supervisor and Slot 02 User Codes) There is a 10-second programming time limit between each step If eLock times out or an error is made, programming will end and you will need to enter programming mode again... -
Page 11: Warranty
USER GUIDE WARRANTY INFORMATION LogiQuip products are covered by a Limited 5-Year Warranty from date of receipt against defect in materials or workmanship under normal use and service, excluding Electronic Components, Cart Covers, Custom Products, and LogiCell Tambour Doors During this...
Need help?
Do you have a question about the eLock and is the answer not in the manual?
Questions and answers