Sealey AK714.V5 Instructions

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to Wear eye
instructions protection
1. SAFETY
WARNING! Ensure that Health and Safety, local authority and general workshop practice regulations are adhered to when using this
‰
product.
DO NOT use this product if damaged.
8
Maintain product in good and clean condition for best and safest performance.
9
If the vehicle to be worked on is raised, ensure that it is adequately supported with axle stands or ramps and chocks.
9
Wear approved eye protection, protective gloves, safety footwear and protective clothing. A full range of personal safety equipment is
9
available from your Sealey stockist.
DO NOT wear loose jewellery and tie back long hair.
8
Account for all tools and parts being used.
9
If working off the vehicle, secure the work piece in a vice or clamp it to a work bench.
9
DO NOT operate puller if you are tired or under the influence of alcohol, drugs or intoxicating medication.
8
IMPORTANT: Always refer to the vehicle manufacturer's service instructions, or a proprietary manual, to establish the current
procedure and data. These instructions are provided as a guide only.
2. INTRODUCTION
Fully chromed carbon steel medium stroke slide hammer. 380mm Overall length with 0.85kg hammer. Bearing extractor collets with
internal capacity from 11-32mm. Supplied in storage case.
3. SPECIFICATION
Model No:
AK714.V5
Nett Weight: 1.48kg
Collet Diameter Ø11-13mm(7/16"-1/2"), 14-17mm(9/16"-11/16"), 16-25mm(5/8"-1"), 25-32mm(1"- 1-1/4")
4. CONTENTS
Part No: AK714.V4-01
Part No: AK714.V4-02
Part No: AK714.V4-03
Part No: AK714.V4-04
Part No: AK714.V4-05
© Jack Sealey Limited
BLIND BEARING PULLER SET 5PC FULLY
CHROMED WITH STORAGE CASE
MODEL NO:
Wear protective
Wear safety
gloves
footwear
11mm - 13mm Attachment
14mm - 17mm Attachment
16mm - 25mm Attachment
25mm - 32mm Attachment
Slide hammer
Original Language Version
AK714.V5
Wear protective
clothing
AK714.V5 Issue 1 27/09/24