Memory Channel; Tion Display; Scanning Operation - Icom IC-M80 Owner's Manual

12
matically return to Channel 16.
(Before Transmitting, be sure that the @ RF POWER
SWITCH is in the proper position for the distance and
needs of your contact. Use 25 watts only when necessary,
to avoid interfering with others trying to use the same
channel in another area.)
MEMORY CHANNEL OPERATION
Memory Writing (Programming the Memory Channels)
1. Push the (9) MEMORY READ BUTTON and a memory
channel will be displayed on the CHANNEL and FUNC-
TION DISPLAY.
2. Rotate the (ў CHANNEL SELECTOR to the channel to
be programmed (MEMO О — 9). As an example, set it at
the memory channel 1 (MEMO 1).
The display will show the memory channel number
"MEMO 1" and the previously programmed channel
number. The radio will receive on this channel.
If no channel has been programmed since first turning
the power ON, "16" will be shown on the display, and the
radio will receive on channel 16.
3. While holding both the MEMORY READ BUTTON
and the @ MEMORY WRITE/DIMMER BUTTON in,
rotate the channel selector, and the displayed channel
number will be changed. Rotate the channel selector so
that the display shows the desired channel, then release
your finger from the MEMORY WRITE/DIMMER BUT-
TON then from the MEMORY READ BUTTON. At this
moment, the desired channel will be memorized into the
selected memory channel. The selected allocation, either
. the "INTL" or "USA", will be memorized as well.
4. Program desired channels into other memory channels in
the same manner. (The weather channels can not be
memorized into any memory channels.)
5. The programmed channels in the memory channels are
maintained by an internal MEMORY BACKUP battery,
even if the radio is removed from the vessel.
Memory Reading
SCANNING OPERATION
All Channel Scan |
To scan all channels (INTL allocation: Channel 1 ~ Channel
88, USA allocation: Channel 6 ~ Channel 88);
1. Engage the SOUELCH, then push the @ DIAL SELECT