Download Print this page
Miller EnPak A60 GBHW Manual
Miller EnPak A60 GBHW Manual

Miller EnPak A60 GBHW Manual

Advertisement

Quick Links

SUPPLEMENTARY DATA
EnPak A60GBHW PDI
The data contained in this supplement is either in addition to or takes exception to data appearing later in this
manual.
ORIGINAL INSTRUCTIONS – PRINTED IN USA
®
EnPak
Pre-Delivery Inspection
Checklist
2023-09
A60 GBHW
FORM: S295530A
© Miller Electric Mfg. LLC 2023-09

Advertisement

loading
Need help?

Need help?

Do you have a question about the EnPak A60 GBHW and is the answer not in the manual?

Questions and answers

Summary of Contents for Miller EnPak A60 GBHW

  • Page 1 The data contained in this supplement is either in addition to or takes exception to data appearing later in this manual. ® A60 GBHW EnPak Pre-Delivery Inspection Checklist ORIGINAL INSTRUCTIONS – PRINTED IN USA © Miller Electric Mfg. LLC 2023-09...
  • Page 2 EnPak A60GBHW ® Pre-Delivery Inspection, Setup, And Testing Check List Customer Company Name: Date: Location/Branch: Customer Contact: Phone: Email: EnPak Serial Number: Truck Chassis: Year: Make: Model: Register your customer’s EnPak at www.MillerWelds.com/registerenpak.  Date: ________________________________________ Name of Up-Fitter Install Representative ________________________________________ Signature of Up-Fitter Install Representative Date:...
  • Page 3: Pre-Delivery Inspection

    Pre-Delivery Inspection Clearances  Top – 24 in. Minimum for top mount fan. Service Side 18 in. Minimum for end mount fan. Fan End  Service Side – 18 in. Minimum  Non-Service Side – 7 in. Minimum  Fan End – 1 in.
  • Page 4 Grounding EnPak  Ground Cable from EnPak to Chassis.  EnPak mechanically bonded to chassis with metal-to-metal contact. Hoses Compressor  ¾ in. ID hose used.  Hose runs direct from EnPak to tank.  20-gallon tank recommended. 10-gallon tank minimum. ...
  • Page 5 Pre-Delivery Setup Compressor ON/OFF Settings Button Start Button Green LED Verify Safety Interlock -Watch Green LED. Should be flashing when Safety Interlock is engaged. Should be OFF when chassis can move. -Press Start button once to turn on Remote. -Press Settings button. -On Settings Screen, select the System Settings option.
  • Page 6 Crane Voltage Threshold For 0V to 12V Step or 0V to 12V Proportional remotes, set to .1V  For IMT Cranes, set higher than .1V For 12V to 0V Proportional remotes, set to slightly less than 12V.  IF unit does not idle down when all loads are off, increase the Crane Voltage Threshold slightly until unit idles down.
  • Page 7 Use of hydraulics Tapping a stick electrode to workpiece (weld equipped units, in stick mode, with Tap To Start Enabled) Chassis battery voltage drops below 12.3 volts  Start the unit with one of the above methods  Set Auto Start/Stop time to desired length Finishing Up ...