Check And Maintenance; Check Points Of Each Use Or Daily; Check Points Of Every 10 Hours - Kubota LA555 Workshop Manual

LA555,LA805,LA1055, WSM

6. CHECK AND MAINTENANCE

CAUTION
• When checking and repairing, park the tractor on flat ground and apply the parking brake.
• When checking and repairing, lower the bucket and stop the engine.

[1] CHECK POINTS OF EACH USE OR DAILY

[2] CHECK POINTS OF EVERY 10 HOURS

Checking Transmission Fluid Level
1. Check the oil level at the gauge (1).
2. If the level is too low, add new oil to the prescribed level at the
oil.
IMPORTANT
• Use only KUBOTA UDT or SUPER UDT fluid.
Use of other oils may damage the transmission or
hydraulic system. Refer to "3. LUBRICANTS" on page G-3.
(1) Gauge
(2) Oil Filling Plug
Checking Hydraulic Hoses
1. With the engine off and bucket on the ground, check all
hydraulic hoses (1) for cuts or wear.
2. Check for signs of leaks and make sure all fittings are tight.
3. If problem are found, replace them.
(1) Hydraulic Hose
(2) Cardboard
Greasing
1. Inject grease in all grease fitting with a hand grease gun.
[A] LA555
Lubricating
1. Lubricate joints of control lever linkage.
G-8
GENERAL
9Y1210861GEG0004US0
(A) Oil level is acceptable within this
range.
9Y1210861GEG0005US0
(3) Magnifying Glass
9Y1210861GEG0006US0
[B] LA805 and LA1055
9Y1210861GEG0007US0
9Y1210861GEG0008US0
KiSC issued 05, 2015 A