Illegal operation is punishable by fine or imprisonment or both. THANK YOU! Founded in 1989, BelFone is a leading technology and solution provider of mission and business-critical communications, dedicated to bringing cut-edge communications technologies and empowering our customers with integrated radio solutions.
Page 4
◆If secondary development is required, please contact with BelFone or the local dealer for technical assistance. ◆Please keep the surface of radio clean and dry. To clean the radio, use a damp fabric soaked in mild washing liquid.
Content Unpacking and Device Inspection ..........01 IInstallation of Accessories ............02 Installing/ Removing the antenna ..........02 Installing/ Removing the belt clip ..........02 Attach the Strap............... 02 Attaching/Removing the Battery ..........03 Battery Information ..............04 Attach the Speaker/Microphone ..........05 Getting Acquainted ..............
Unpacking and Device Inspection Notes: The following instructions regarding unpacking are only for BelFone’s distributors, and service agencies or factories authorized by BelFone. After carefully unpacking the radio, identify the items listed in the table below. If any items are missing or have been damaged during shipment please contact dealer or BelFone immediately.
Installation of Accessories Installing / Removing the antenna Hold the supplied antenna by its base, then screw it into the connector on the top panel of the radio until fasten. Turn the antenna anti-clockwise to remove it. Installing/ Removing the Belt Clip Attach the belt clip using the two supplied3*4mm binding screws.
Attaching/Removing the Battery Warning! Don’t short-circuit the battery, which may cause damaged or catch fire; Don’t attempt to remove the case of the battery to prevent battery short circuit; Battery is flammable and explosive, don’t throw it into fire or don’t use it in dangerous area, such as gas stations.
Applicable Battery To reduce the risk of injury, please only use the battery and charger specified by BelFone, other batteries may burst, causing bodily injury and property damage. Battery Tips 1.Batteries charge best at room temperature within 5℃—40℃, or it’ll lead to battery leakage and damage.
3.Store the battery in a cool, dry place under room temperature to reduce self-discharge. Charging the battery Use only the charger specified by the manufacturer, and the charge indicator indicates the charging progress. Charger Status Charger Indicator Standby(No-load) Green Battery is charging Battery is fully charged Green Charge Steps:...
Getting Acquainted Channel Selector Knob ① ⑥ Power &Volume Knob ② ⑦ PTT Key Button 1: Press and hold to ⑧ monitor, release to cancel ③ LED Indicator monitor by default. Button 1: Short press the key to switch the lamp mode, long ⑨...
Basic Operation Turning the Power on /off Rotate the power &volume knob clockwise to turn the power on. Rotate the power &volume knob anti-clockwise to turn the power off. Adjust the Volume After the radio is powered on, rotate the power &volume knob to adjust the volume level, rotate the knob clockwise to increase the volume, or rotate the knob anti-clockwise to decrease the volume.
The radio supports voice noise suppression function, which can suppress environmental noise and ensure clear voice call quality. Note: Only BF-312 version supports noise suppression function. Tone Prompts When turning on the radio or switching channels, the radio will broadcast the current channel number;...
Battery Save Enable battery save mode will extend battery service life, but the response time of the radio may be delayed. Power save ratio can be set to 1:1, 1:2, 1:3, 1:4 via the programming software, the smaller the rate, the more obvious the power save.
Lamp This radio supports lamp function with three flashlight modes: constant light, fast flash, and SOS mode (three short lights, three long lights, and three short lights, cycling in sequence). Short press Button 2 to keep the lamp on, then short press to switch the flashlight mode to fast flash, then short press to switch the flashlight mode to SOS mode, and then short press to turn off the lamp.
CTCSS/CDCSS Users can set unique CTCSS or CDCSS to guarantee the quality of communication. If CTCSS or CDCSS has been set on the current channel, CTCSS/CDCSS match is required for the radio to receive an incoming signaling. When current channel is set with CTCSS or CDCSS, users can select sub tone mode as normal signaling or special signaling.
This manual has been compiled with the utmost effort to ensure the accuracy and completeness of its content. For any doubt, please contact BelFone. We will give you professional answers. As radio communication technologies develop rapidly, BelFone reserves the right to change...
Need help?
Do you have a question about the BF-312 and is the answer not in the manual?
Questions and answers