Program And Controller Dumps - Clavia Nord Electro 2 User Manual

NORD ELECTRO 2 V3.0x
However, in our example this wouldn't help much, because the Drawbar opening was the first Controller
message recorded in the song. The sequencer has no information about the Drawbar setting before the re-
corded change, and therefore cannot "chase" the settings properly. To solve this, you could record a "snap-
shot" of all Controller settings of the Nord Electro 2 Program(s) at the beginning of your sequencer song.
This can be done by using the 'MIDI Controllers Dump' function described below.
P
ROGRAM AND
To dump Program Sysex or MIDI Controllers via MIDI, to another Nord Electro 2 or for recording the
data into another MIDI device, do like this:
1. Connect a cable from MIDI O
2. Set up the receiving device so that it accepts MIDI Sysex and MIDI Controller data.
3. Press the S
HIFT
enter the Dump menu. Select what to dump by press-
ing the U /D
P
in the D
ISPLAY
means 'All Programs Dump' and 'Ct' means 'MIDI
Controllers Dump'. If you're about to dump a single
Program or MIDI Controllers for a Program, select the
Program by choosing Program Bank with the U
D N
OWN AVIGATOR
the corresponding P
4. If needed, set the receiving MIDI device to "recording
mode".
5. Press the S
TORE
O of Nord Electro 2. The Display will stop flashing
UT
once the dump has been sent.
Note: For Sysex dumps of Organ sounds, the complete settings for the sound will be dumped as
MIDI Sysex. For Piano sounds, all parameters will be sent but NOT the actual instrument sam-
ples. Therefore, when dumping back a Piano Sysex, make sure the actual instrument sound is
already loaded in the Nord Electro 2. Otherwise the parameters in the Sysex message will be
applied to another available Piano instrument. However, the Nord Electro 2 works in an intelli-
gent way regarding substituting Piano sounds.Let's say you dumped a Program Sysex based on the
E.Piano1 sound and then erased the E.Piano1 sound. When you load the Program Sysex back to
the Electro 2, it will apply another available Electric Piano sound, the E.Piano2 or E.Piano3, for
example. If no Electric Piano sound is available, another piano sound will be applied.
C
ONTROLLER DUMPS
on the Nord Electro 2 to MIDI In on the receiving device.
UT
+ L O S
EFT CTAVE
N buttons. 'Pr' flashing
OWN AVIGATOR
means 'single Program Dump', 'Al'
buttons and Program by pressing
button.
ROGRAM
button to send the dump to the MIDI
7. MIDI functions: Program and Controller dumps
buttons to
HIFT
/
P
Page 43