Advertisement
Quick Links
RE305_eng-01
ANT042 dual band antenna with SMB cable adapter
The following instructions apply to the spare parts listed below:
Read the Instruction Manual
and the Technical Data Sheet
and keep it at hand.
Always wear a grounded wrist
strap
A
B
G
Place the antenna as shown in the Radio Remote Control's Instruction Manual.
Periodically make sure that the FME connector [G], the SMB connector [J] and the stylus [F] are properly tightened.
The thickness of the metal surface where the antenna will be mounted shall not exceed 3.5mm.
Key
© 2021 Autec Srl
Do NOT use oil and/or
lubricants
Description
C
F
D
H
E
J
Tools and consumable materials
A
Nut (Do not use)
B
Washer (Do not use)
C
Ring nut
D
Gasket
E
TNC-FME adapter
F
Antenna
G
FME connector
H
Antenna cable
J
SMB connector
Do NOT use water
1 / 4
Advertisement
Related Manuals for AUTEC ANT042
Summary of Contents for AUTEC ANT042
- Page 1 RE305_eng-01 ANT042 dual band antenna with SMB cable adapter The following instructions apply to the spare parts listed below: Read the Instruction Manual Do NOT use oil and/or and the Technical Data Sheet Do NOT use water lubricants and keep it at hand.
- Page 2 Firmly grab the SMB connector [J]. Avoid grabbing the The cable [H] has been approved at the length at which antenna cable [H], in order not to damage the cable itself. it is supplied: never shorten or cut it. 2 / 4 © 2021 Autec Srl...
- Page 3 Grab the antenna cable near the SMB connector [J] and make sure that it is blocked by pulling it gently; if that is not the case, repeat the previous step. Disassembly Firmly grab the SMB connector's [J] ring nut. Pull and disconnect the Unscrew the FME connector [G] from the TNC-FME adapter [E].
- Page 4 Remove the TNC-FME adapter [E].
Need help?
Do you have a question about the ANT042 and is the answer not in the manual?
Questions and answers