Advertisement
GBS
PRODUCT SAFETY
When using electrical equipment, basic safety precautions should always be followed, including the following:
READ THESE INSTRUCTIONS BEFORE USING THIS PRODUCT.
Do not let power supply cords touch hot surfaces.
Do not mount near gas or electric heaters.
Equipment should be mounted in locations and at
heights where it will not readily be subjected to
tampering by unauthorized personnel.
SAVE THESE INSTRUCTIONS.
GETTING STARTED
Overview
The GreenBus Sensor(GBS) family of ceiling/surface mount sensors provides a range of networked sensor solutions for applica-
tions with finished ceilings (e.g. ceiling tiles, sheetrock, plaster). They combine passive infrared (PIR) and photocell sensing in a
single compact form factor.
The GBS is available in three models:
•
Standard Range
•
Extended Range
•
High-Bay
INSTALLATION INSTRUCTIONS
The use of accessory equipment is not
recommended by Encelium as it may cause an
unsafe condition.
Do not use this equipment for other than the
intended use.
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Encelium GreenBus Sensor Series
Summary of Contents for Encelium GreenBus Sensor Series
- Page 1 READ THESE INSTRUCTIONS BEFORE USING THIS PRODUCT. Do not let power supply cords touch hot surfaces. The use of accessory equipment is not recommended by Encelium as it may cause an Do not mount near gas or electric heaters. unsafe condition.
- Page 2 WIRED SYSTEM OVERVIEW GreenBus is a low-cost, high reliability communication means to report sensor information back to the Encelium X and to obtain optimum brightness settings for light luminaires. The GreenBus wiring originates at the Wired Manager and propagates in a daisy-chain from module to module (or other compatible equipment).
- Page 3 The sensor provides a 360° coverage pattern. Encelium recommends that the sensor be installed more than 1.2 m (4 ft) away from air supply vents.
-
Page 4: Mounting Options
INSTALLATION INSTRUCTIONS MOUNTING OPTIONS The sensor can be mounted in a variety of ways depending on the type of ceiling. Magnetic Mount Surface Mount Ceiling Tile Mount Junction Box Mount Magnet Location Ceiling Tile Mount and Junction Box Mount requires optional mounting kit (sold separately). Option 1 —... -
Page 5: Option 2 - Surface Mount
INSTALLATION INSTRUCTIONS Option 2 — Surface Mount The sensor may be installed directly to a ceiling surface (ceiling tile, drywall ceiling, etc). There are several screw options available to affix the sensor directly to ceiling surfaces. Helical Screw Thumb Screw Drywall or Wood Screw (#6) Option 3 —... -
Page 6: Electrical Connections
INSTALLATION INSTRUCTIONS Option 4 — Junction Box Mounting Ring ELECTRICAL CONNECTIONS GBS Wiring Terminal blocks are pre-wired on the wires out of the box and are wired as shown. Previous Device Next Device Splicing Connector X4 GBS Installation Instructions | Installationsanleitung | Instructions d'installation | Instrucciones de Instalación... -
Page 7: Installation Testing
INSTALLATION INSTRUCTIONS INSTALLATION TESTING Installer can quickly test if the devices have been wired correctly by pressing any button on the wallstation or the sensor which triggers all the load controllers on the channel to change the dimming level by 25%. Every press will trigger this function to enable testing of the AC line wiring, dimming wiring and communication integrity over the GreenBus lines. -
Page 8: Installation Instructions
Remove the Ring Install Mask Lens Surround Lens Surround © Copyright 2024 Legrand All Rights Reserved. © Copyright 2024 Legrand Alle Rechte vorbehalten © Copyright 2024 Tous droits réservés Legrand. © Copyright 2024 Legrand Todos los derechos reservados. encelium.com 080442r1 01/24...
Need help?
Do you have a question about the GreenBus Sensor Series and is the answer not in the manual?
Questions and answers