Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for TRENDnet TE-500PLUS
Summary of Contents for TRENDnet TE-500PLUS
- Page 1 TE-500plus TE-800plus TE-910plus Palm Size 10Base-T Ethernet Hub User’s Guide...
-
Page 3: Fcc Warning
This equipment has been tested and found to comply with the regulations for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated commercial environment. -
Page 4: Table Of Contents
Table of Contents INTRODUCTION................1 ..............1 RODUCT EATURES PALM SIZE HUB .......2 RONT ANEL OF PALM SIZE HUB .........3 ANEL OF LED I ................4 NDICATORS ............4 ANEL ONNECTORS Twisted-pair Jacks..............4 Uplink Jack................5 Power Jack................5 INSTALLATION................6 ..............6 NSTALLING THE ..........6... -
Page 5: Introduction
?? RJ45 ports support Category 3 or better twisted-pair cable. ?? LED indicators for each twisted pair port for link and receive status. ?? Uplink jack for easy linking of two hubs to further expand the network. ?? Compact in size. -
Page 6: The Front Panel Of Palm Size Hub S
The Front Panel of The Hub 5-port Ethernet Hub 8-port Ethernet Hub 9-port Ethernet Hub with BNC port... -
Page 7: The Rear Panel Of Palm Size Hub S
The Rear Panel of The Hub 5-port Ethernet Hub 8-port Ethernet Hub 9-port Ethernet Hub with BNC port... -
Page 8: Led Indicators
(server/workstation/print server) to the hub. These are MDI-X (Medium Dependent Interface, Cross-Wired) jacks, which means you can use ordinary stright-through twisted-pair cables to connect workstations and servers to the hub. If you need to connect another device with an MDI-X jack, such as another... -
Page 9: Uplink Jack
Ethernet switch, you should use a crossver cable, or make the connection using the Uplink jack. Uplink Jack The Uplink jack is an MDI-II jack, which means you can connect the hub to an Ethernet device’s (i.e. Hub or Switch) MDI-X port using straight-through cable. -
Page 10: Installation
(i.e. motors), vibration, dust, and direct exposure to sunlight. ? ? Leave at least 10 cm of space at the front and rear of the hub for ventilation. Note not to block the ventilation holes on the top of the hub. -
Page 11: Cables And Connectors
Twisted-Pair Cable: Category 3 or better unshielded twisted-pair or EIA/TIA-568 compliant, 100-ohm shielded twisted-pair data cable with 0.4 to 0.6 mm (22 to 26 AWG) wires in two or four twisted pairs (only two pairs, four wires, are used for 10BASE-T). -
Page 12: Crossover Cables
In a crossover cable, two pairs of wires are switched at one end. Carry out the following steps to create a crossover twisted-pair cable: Leave one end of the cable as -is, with the wiring on the RJ-45 connector unchanged. The wiring needs to be modified at one end only. -
Page 14: Specifications
Protocol: CSMA/CD Network Data Transfer Rate: 10Mbps (Ethernet) Number of Ports: 5 x STP / 8 x STP / 8 x STP + 1 x BNC Network Media: Category 3 or better UTP cable, maximum length 100 meters. Thin coax RG-58U or RG-58 A/U cable maximum 185 meters.
Need help?
Do you have a question about the TE-500PLUS and is the answer not in the manual?
Questions and answers