Related Manuals for Truper Expert MADE-10NX-2
Summary of Contents for Truper Expert MADE-10NX-2
- Page 1 Manual Variable speed SDS MAX 6 J - 25 J Demolition hammer Impact energy MADE-10NX-2 Applies for: Code Model 102469 MADE-10NX-2 Read this manual thoroughly CAUTION before using the tool.
-
Page 2: Table Of Contents
Manual before using the tool. Parts Preparation Keep this manual for future references. Start up The illustrations in this manual are for reference only. They might be different from the real tool. Maintenance Notes Authorized service centers Warranty policy MADE-10NX-2 ENGLISH... -
Page 3: Technical Data
Technical data MADE-10NX-2 Code 102469 Description SDS MAX Demolition hammer Chuck SDS max Voltage 220 V~ Frequency 50 Hz / 60 Hz Corriente Power Impact energy 1500 W 6 Joules - 25 Joules Weight 22 lb Impact rate 1 000 strokes/min - 1 900 strokes/min Work cycle 50 minutes work per 20 min rest. -
Page 4: General Power Tool Safety Warnings
General power tool safety warnings WARNING! Read carefully all safety warnings and instructions listed below. Failure to comply with any of these warnings may result in electric shock, fire and / or severe damage. Save all warnings and instructions for future references. -
Page 5: Safety Warnings For The Use Of Demolition Hammer
Safety warnings for the use of demolition hammers Choose the appropriate drill or attachment While operating the demolition hammer CAUTION • The tool is designed to work with bits CAUTION • Hold the tool by its handle and by or accessories with SDS-max shanks. Choose the the auxiliary handle. -
Page 6: Parts
Parts Type D auxiliary SDS max Vibration Anti-skid handle Shank Chuck collar absorber handle protection Power trigger Ring for adjusting the required angle Speed adjustment knob Off switch Spare Carbon Power Cord Carbon brushes Brushes Protection wear indicator Grease Power Tube Cord Preparation... -
Page 7: Start Up
Preparation Chisel accessory installation and removal CAUTION To prevent accidents, confirm that the switch is turned off and disconnect the plug from the power supply. Always wear gloves when changing accessories. WARNING They can become extremely hot during operation. • Clean the drill bit shank (A) and apply grease before inserting it •... - Page 8 Start up Chisel angle adjustment • The chisel can be adjusted in 12 positions, depending on the job to be done. • Insert the chisel into the chuck as shown on page 7. • Push forward and turn the ring (A) to change the chisel to the desired position.
-
Page 9: Maintenance
Maintenance Cleaning and Care Lubrication • Clean the machine with a soft cloth, dampened with soap It is recommended that the tool transmission be lubricated and water, preferably after each use. every time the carbons are changed at an • Always keep the vents clean and free of obstructions to TRUPER Authorized Service Center. -
Page 10: Notes
Notes ENGLISH... -
Page 11: Authorized Service Centers
Authorized service centers In the event of any problem contacting a TRUPER Authorized Service Center, please see our webpage WWW.TRUPER.COM to get an updated list, or call our toll-free numbers 800 690-6990 or 800-018-7873 to get information about the nearest Service Center. AGUASCALIENTES DE TODO PARA LA CONSTRUCCIÓN MORELOS... -
Page 12: Warranty Policy
Model Brand 102469 MADE-10NX-2 Warranty. Duration: 5 years. Coverage: parts, components and workmanship against manufacturing or operating defects, except if used under conditions other than normal; when it was not operated in accordance with the instructive; was altered or repaired by personnel not authorized by TRUPER .
Need help?
Do you have a question about the MADE-10NX-2 and is the answer not in the manual?
Questions and answers