Motorola T250 Manual page 26

          
Connecting Data Cable
Please refer to the desktop charger instruction literature.
Battery Indicators on the Phone Display
Your Motorola cellular phone includes the Motorola Expert
Performance ( ) charging system. This enables the charging
circuits in both the phone and the optional (
charger to communicate directly with the battery. Based on this
communication, the charger can implement the optimum
charging cycle for best performance and determine the level of
charge.
Your phone monitors and displays information about your
battery. The following message will appear on the phone display,
as the condition occurs:
The battery charge is low. The battery should
be recharged.
No battery fitted; external power connected
This message is accompanied by a single beep.
Your phone is alerting you that you do not
have charging capabilities with this battery
even though the battery may be able to power
the phone.
The most likely reason why your charging
system does not recognise the battery is that
the battery you have purchased is not a
Motorola original battery and therefore does
not have the communications technology built
into it. All Motorola original batteries include
this communications technology.
English 22
About Your Phone, Battery and SIM Card
It is recommended that you use only Motorola
original batteries, chargers and other
accessories.
Battery Indicators on the Desktop Charger
The following LED indicators flash/light on the desktop charger
) desktop
base, as the condition occurs:
Front pocket phone indicator
Lights up yellow only when the phone is properly
seated in the charger. Check the charging status on
the phone display. If there is a battery in the back
pocket and the phone display is off, the phone battery
is fully charged.
Back pocket battery indicator
Left side solid red indicates that the battery is charging;
right side flashing yellow indicates that the battery is
waiting to be charged; both sides solid green indicates
that the charging is complete (battery > 90%
charged); both sides flashing red indicates an invalid or
faulty battery has been detected or that there are two
batteries in the back pocket and the batteries will not
be charged.
Data indicator
Flashes green only when data is transferring to an
attached PC with the appropriate optional data cable.
Data transfer must be initiated through the PC.
:
:
: