Download Print this page

Jireh MOTIX Small Diameter Clamp User Manual

Download this manual

MOTIX Small Diameter Clamp

THIS MANUAL IS PART OF THE MOTIX SYSTEM AND MUST BE RETAINED FOR

THE LIFE OF THE PRODUCT. PASS ON TO SUBSEQUENT OWNERS.

Ensure any amendments are incorporated with this document.

INSTALLING ON CARRIAGE

- Disconnect the adapter block

Fig. 1

Utilize a 3 mm hex key to unscrew the four adapter block screws (Fig. 1-A).

Detach the adapter block from the main assembly (Fig. 2-B).

Bolt the three adapter block screws to attach the adapter block to the crawler (Fig. 2).

Bolt the four screws of the main assembly to the adapter block (Fig. 2).

USER MANUAL

KEEP THIS MANUAL – DO NOT LOSE

53158 Range Road 224

Ardrossan, AB

Canada, T8E 2K4

- Attach adapter block and main assembly to the crawler

Fig. 2

EJ0087 Rev 00

Need help?

Do you have a question about the MOTIX Small Diameter Clamp and is the answer not in the manual?

Page 1 MOTIX Small Diameter Clamp USER MANUAL KEEP THIS MANUAL – DO NOT LOSE THIS MANUAL IS PART OF THE MOTIX SYSTEM AND MUST BE RETAINED FOR THE LIFE OF THE PRODUCT. PASS ON TO SUBSEQUENT OWNERS. Ensure any amendments are incorporated with this document.
Page 2 INSTALLING ON PIPE - Adjust red knob to align threads with pin - Twist to lower base Fig. 3 Fig. 4 Rotate the fine adjustment knob counterclockwise until the threads are aligned flush with the pin (Fig. 3). When required, twist the vertical release knob to lower the base, creating extra clearance for fitting onto the pipe (Fig.
Page 3 REMOVAL FROM PIPE - Loosen knob - Adjust base to remove crawler Fig. 8 Fig. 9 Loosen the fine adjustment knob until the end of the threads are flush with the pin, or until there is adequate clearance to remove the crawler from the pipe (Fig. 8). If necessary, rotate the vertical release knob to allow the base to slide down, providing more clearance to remove the crawler from the pipe (Fig.
Page 4 Reassemble the clamp by reversing steps 1 and 2, sliding the clamp arms up from the bottom to reinstall the base onto the main assembly (Fig. 14). It will be necessary to turn the vertical release knob to attach the base to the main assembly. 780.922.4534 EJ0087 Rev 00 jireh.com...

Eja005