Setup And Product Care; Getting Connected - Motorola STARTAC CLIPON Manual

Getting connected

To set up your StarTAC Clip-On Mobile Organizer for
synchronization, you will need to:
1 use the cable included with your purchase and connect it to
your computer, and
2 connect the StarTAC Clip-On to your telephone.
These steps are described below. (For details on system
requirements, please read "Requirements" on page 36.)
To connect the Clip-On to your computer:
1 Connect the cable to the Clip-On and your computer.
2 You should hear a connection tone.
To connect the Clip-On to your telephone:
.
1 The Clip-On uses the auxiliary battery connector on the
back of the phone. Insert the spring clip on top of the Clip-
On into the connector, and pull it down (the clip is spring-
loaded).
2 Insert the connector on the bottom of the Clip-On into the
connector on the StarTAC telephone.
31
Setup and
Chapter 3
product care

Setup and product care

3
31