Hide thumbs Also See for 70030:

Advertisement

Quick Links

I N S T R U C T I O N F O R U S E
Item no.: Model
70030
VELA X-Ray Chair
70031
VELA 'Turn+' Thorax Chair
70032
VELA Mammography Chair
70033
VELA 'Basic+' Ophthalmology Chair
70034
VELA 'Move+' Ophthalmology Chair
70035
VELA 'Medium' Exercise Chair
70036
VELA 'Large' Exercise Chair
70037
VELA 'Support' Surgeon's chair
70038
VELA 'Advance' Phlebotomy chair
VELA Medical
ISO 9001
ISO 14001
The chair's design varies depending on the model
E N
Manual no. 106057

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 70030 and is the answer not in the manual?

Questions and answers

Summary of Contents for VELA Medical 70030

  • Page 1 I N S T R U C T I O N F O R U S E VELA Medical Manual no. 106057 Item no.: Model 70030 VELA X-Ray Chair 70031 VELA ’Turn+’ Thorax Chair 70032 VELA Mammography Chair 70033 VELA 'Basic+' Ophthalmology Chair...
  • Page 2: Table Of Contents

    TABLE OF CONTENTS 1.0. INTRODUCTION 1.1. WARNINGS 1.2. TROUBLESHOOTING 1.3. VELA TANGO WITH ELECTRIC HEIGHT ADJUSTMENT 1.3.1. Power input 1.3.2. Emission 1.3.3. Surge protection 1.4. LABELS USED ON THE CHAIR 1.5. SAFETY 1.5.1. Intended use 1.5.2. Transport 1.6. WARRANTY 1.7. UNPACKING THE CHAIR 1.8.
  • Page 3: Introduction

    If you have questions, experience errors or adverse events, please contact your VELA Medical dealer. VELA Medical reserves the right to make changes to this manual. VELA Medical Gøteborgvej 8-12...
  • Page 4: Warnings

    1.1. WARNINGS In case of an allergic reaction, stop using the chair and consult a doctor Only use original spare parts from VELA Medical Only use the supplied charger for charging the chair Do not make any changes to the accessories that come with the chair...
  • Page 5: Troubleshooting

    There is too much load or uneven load on the chair. Try to adjust the height without sitting in the chair. If this does not work, the gas cartridge is defective and should be replaced. Contact your VELA Medical supplier The brake function does not work The brake is not activated.
  • Page 6: Vela Tango With Electric Height Adjustment

    Current: 0.5A Power: 12VA 1.3.2. EMISSION A VELA Medical chair with electrical functions has been tested and complies with current requirements regarding electromagnetic radiation (EMC require- ments). The chair is tested to the following specifications: :: Emission class CISPR 11, Group 1, Class B See more details at www.vela-medical.com...
  • Page 7: Labels Used On The Chair

    ”VELA Tango” and conforms to all 1.5.1. INTENDED USE applicable EU rules. The chair is This device is intended to support manufactured by VELA Medical, a user in a sitting posture while Goeteborgvej 8-12, 9200 Aalborg performing indoor activities of daily SV, Denmark.
  • Page 8: Transport

    On delivery you have received: :: VELA Medical chair 1.6. WARRANTY :: Instructions for use VELA Medical grants a right of claim :: Charger (only for chairs with elec- under applicable law in the country trical functions) where the chair is acquired. The right of complaint applies only when using Note: see item 2.0.1 for correct...
  • Page 9: Wheels

    VELA Medical, your VELA together with ordinary household Medical supplier or a trained profes- waste. Proper disposal and recycling...
  • Page 10: Settings

    2.0.2. HEIGHT ADJUSTMENT VIA HAND BOX (EL) The hand box is used via push buttons on the front. VELA Medical hand boxes can have one or more functions. The icons on the hand box show the button functions. Note: Insert plug in hand box to operate functions. Should only be used continuously for one minute, then a nine-minute break should follow.
  • Page 11: Setting Angle Of Seat

    Note: Setting the angle of backrest and seat should always be done with your feet flat on the floor. 2.0.4. SETTING ANGLE OF SEAT* Adjusted by pulling up the middle handle on the right-hand side. 2.0.5. SETTING ANGLE OF BACKREST Adjusted by pulling up the rear handle on the right-hand side.
  • Page 12: Back Bolt

    2.0.8. BACK BOLT* The backrest can be set to a specific angle by adjusting and attaching the bolt mounted on the back of the backrest. Note: This function can only be set using tools on certain models. 2.0.9. ADJUSTING THE ARMREST HEIGHT* Adjusted by loosening the screw on the armrest bar and adjusting the height of the armrest.
  • Page 13: Rotation

    A ( 0,08 : 1 ) 2.0.12. ROTATION* The seat is rotated by pushing back on the front handle on the left-hand side. Rotation can be turned and locked in the following positions: 90° to the left, 0° (neutral), and 90° to the right.
  • Page 14: Strolling Bracket

    2.0.16. STROLLING BRACKET* Strolling bracket for transporting a person in the chair. The strolling bracket is mounted to fittings under the seat using two screws (See the enclosed ziplock bag). This is also where the depth is adjusted. The height is adjusted by pressing the two buttons on the side of the bracket while the handle is positioned at the desired height.
  • Page 15: Battery Indicator (El)

    2.0.20. BATTERY INDICATOR (EL) A battery indicator with a button is located on the front of the chair just below the seat. One press shows the remaining battery capacity in per cent (%). Two presses show the remaining battery voltage. .21.
  • Page 16: Accessories

    See a complete list of accessories at: www.vela-medical.com Note: Charger is included as an accessory when purchasing a Medical VELA chair with electrical functions. VELA Medical :: Gøteborgvej 8-12 :: 9200 Aalborg SV :: Denmark :: +45 96 34 76 00 :: mail@vela-medical.com vela-medical.com...

Table of Contents