GKOLED GKOFDG11 Series Installation Manual

PLEASE READ ALL INSTRUCTIONS BEFORE ATTEMPTING INSTALLATION
— To prevent personal injury or product damage only licensed electricians should install.
— To avoid electric shock or component damage disconnect power before attempting installation or servicing.
— This product must be installed in accordance with the national electric code (NEC) and all applicable federal, state and local electric codes and safety standards.
— Disconnect product and allow cooling prior to servicing.
—
—
—
— This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and
the hazards involved.
—
—
— If installing product with lens facing up, ensure the lens is kept free of debris to minimize the risk of damage to the product.
— This product is not suitable for several special environments, such as places with corrosive gas liquids or high pressure water vapor.
Installation Guide
1/2" NPS Knuckle Mount (Figure 1)
For 15W | 27W | 40W | 65W Only
OPTIONAL: Ground Stake Mount
1. IMPORTANT: Installation and service of luminaire should only be performed by
Electrical code and all applicable codes and ordinances. Make sure water does
covered by a cap by default. To activate the photocell, remove the photocell cap
IMPORTANT: " NPS thread using waterproof silicone sealant during
installation to prevent water ingress.
Trunnion Mount (Figure 2)
For 15W | 27W | 40W | 65W Only
1. IMPORTANT: Installation and service of luminaire should only be performed by
trunnion bracket.
Electrical code and all applicable codes and ordinances.
covered by a cap by default. To activate the photocell, remove the photocell cap
®
" screw bracket onto a weatherproof Junction
FLOOD LIGHT
WARNING
Waterproof Ring
15W / 27W
40W / 65W
Series GKOFDG11
Installation Guide
Silicon Rubber
Waterproof Gasket
Screw
" Screw Bracket
" Locknut
L N
(Not Included)
(Figure 1)
L
N