Page 2
Auch die Wahl des Ortes, wo du trainieren möchtest, erweitert sich auf allen Wänden und Decken oder auch an Türrahmen. Unser Ziel von CLEVO ist es, so viele Kunden wie möglich mit unseren hoch- wertigen Produkten dabei zu unterstützen, ein 100% flexibles Training zu er- möglichen.
Benutzerhandbuch Inhaltsverzeichnnis S. 4 Sicherheitshinweise S. 4 Aufbewahrung und Pflege S. 6 Montageanleitung - HOLZPLATTE S. 8 Montageanleitung - WAND S. 12 Garantie und Rückgaberecht S. 13 Kontakt...
2. Die MAXIMALE BELASTBARKEIT von 100 KG darf beim Klettern bzw. bei der Nutzung unter keinen Umständen überschritten werden! 3. Grundsätzlich wird die Montage des Gerätes an den CLEVO Klettermodu- len (CLEVO DOOR, CLEVO WALL, CLEVO-S, -M, -L und -XL) empfohlen.
Reinigungsmittel, da diese die Oberfläche beschädigen oder Kratzer verursa- chen können. Das Holz des CLEVO Hangboards ist naturbelassen. Bei Bedarf kann das Holz mit einem Schleifpapier bearbeitet werden, um dessen Oberfläche zu glätten. Verwende in diesem Fall nur ein Schleifpapier mit feiner Körnung (Körnung: 120).
CLEVO Klettermodule (CLEVO DOOR, CLEVO WALL, CLEVO-S, -M, -L und -XL) ausschließlich das mitgelieferte Schraubenset. Solltest du das Hangboard an eine andere Holzplatte bzw. an eine Holz- platte mit einer Dicke von > 20 mm, montieren wird empfohlen, dement- sprechend längere Holzschrauben zu verwenden.
Page 7
Align the supplied drilling template, fix it with a tape to desired position (on the wooden plate or on the wall) and mark the holes. Make sure that the sheet is tight. Then measure the marked points again! A.) When mounting on wooden plate (e.g. on CLEVO modules): Drill the holes with 3 mm drill diameter through the wooden plate.
Setze auf jede Schraube eine Scheibe und eine Mutter. Nutze den Inbusschlüs- sel und den Ringschlüssel und schraube die 5 Schrauben nacheinander fest. Achte darauf, dass die Schrauben fest sitzen und das Hangboard an der Platte sicher fixiert ist. Schritt 5 Führe einen ersten Hangtest vorsichtig durch, um die Fixierung des Hang-...
Page 9
Align the supplied drilling template, fix it with a tape to desired position (on the wooden plate or on the wall) and mark the holes. Make sure that the sheet is tight. Then measure the marked points again! A.) When mounting on wooden plate (e.g. on CLEVO modules): Drill the holes with 3 mm drill diameter through the wooden plate.
Page 10
Schritt 2 Nachdem alle 5 Löcher markiert wurden, kann das Hangboard von der Wand genommen werden. Messe die markierten Punkte an der Wand ggf. noch ein- mal nach und stelle sicher, dass diese den Abständen der Löcher des Hang- boards entspechen.
Page 11
Schritt 4 Schraube mit dem Akkuschrauber nacheinander die 5 Schrauben langsam in die Dübel hinein bis die Schrauben fest sitzen und das Hangboard an der Wand fixiert ist. Falls sich die Dübel in der Wand drehen sollten, müssen andere oder größere Dübel genommen werden.
Rücksendung unfrei vorzunehmen. Setze dich im Falle eines Garantiefalles umgehend mit unserem Serviceteam in Verbindung: info@clevo-climbing.com Um die Ware im Falle einer Retoursendung ausreichend zu schützen, bitten wir dich, falls möglich, die Originalverpackung für die Dauer der Garantiezeit aufzu- bewahren. Bitte kontaktiere in jedem Fall unbedingt vorab unser Serviceteam.
6 Kontakt Seite 13 Fragen oder Kommentare? CLEVO Climbing Evolution FT Fitness Technology GmbH Im Oberhof 4 88260 Argenbuehl, Germany www.clevo-climbing.com +49 89 215300-747 info@clevo-climbing.com instagram.com/clevoclimbing/ facebook.com/clevoclimbing youtube.com/@clevoclimbing Solltest du weitergehende Fragen zum Produkt oder Schwierigkeiten bei der Montage des Produktes haben, kannst du uns sehr gerne kontaktieren.
Page 14
Also, the choice of where you want to train expands to all walls and ceilings or even door frames. Our goal at CLEVO is to support as many customers as possible with our high quality products to enable a 100% flexible training.
Page 15
User Manual Table of contents p. 16 Safety Instructions p. 17 Storage and Care p. 18 Assembly Instruction - WOODEN PLATE p. 21 Assembly Instruction - WALL p. 24 Guarantee and Return Policy p. 25 Contact...
2. The MAXIMUM LOAD CAPACITY of 100 KG must not be exceeded under any circumstances during climbing or use! 3. Basically, it is recommended to mount the product on our CLEVO climbing modules (CLEVO DOOR, CLEVO WALL, CLEVO-S, -M, -L and -XL).
Store your hangboard indoors. Avoid exposing the product to direct sunlight or moisture when storing it. Do not store the product near sources of heat. Clean the hangboard with a damp, soft and clean cloth. Do not use abrasive, corrosive, acidic or alkaline cleaning agents, as these may damage the surface of the appliance or cause scratches.
18 Important instructions for assembly 1. Please use only the supplied screw set for mounting your hangboard on the wooden plates of CLEVO climbing modules (CLEVO DOOR, CLEVO WALL, CLEVO-S, -M, -L and -XL). If you mount the hangboard on an another woo- den plate or on a wooden plate with a thickness of >...
Align the supplied drilling template, fix it with a tape to desired position (on the wooden plate or on the wall) and mark the holes. Make sure that the sheet is tight. Then measure the marked points again! A.) When mounting on wooden plate (e.g. on CLEVO modules): Drill the holes with 3 mm drill diameter through the wooden plate.
Step 5 Carefully perform an initial hang test to check the fixation of the hangboard. After climbing several times, check the fixation again and retighten the screws if necessary.
Page 21
Align the supplied drilling template, fix it with a tape to desired position (on the wooden plate or on the wall) and mark the holes. Make sure that the sheet is tight. Then measure the marked points again! A.) When mounting on wooden plate (e.g. on CLEVO modules): Drill the holes with 3 mm drill diameter through the wooden plate.
Page 22
Step 2 After all 5 holes have been marked, the hangboard can be removed from the wall. If necessary, measure the marked points on the wall again and make sure that they correspont to the distances of the holes of the hangboard.
Page 23
If the dowels turn in the wall you need to use other or larger dowels for mounting the hangboard. Step 5 Carefully perform an initial hang test to check the fixation of the hangboard. After climbing several times, check the fixation again and retighten the screws if necessary.
In the event of a guarantee case, please contact our service team immediately: info@clevo-climbing.com In order to protect the product sufficiently in case of repair or return, we ask you to keep the original packaging for the duration of the warranty period, if possib- le.
6 Contact page 25 Questions or comments? CLEVO Climbing Evolution FT Fitness Technology GmbH Im Oberhof 4 88260 Argenbuehl, Germany www.clevo-climbing.com +49 89 215300-747 info@clevo-climbing.com instagram.com/clevoclimbing/ facebook.com/clevoclimbing youtube.com/@clevoclimbing If you have any further questions about the product or difficulties with the instal- lation of the product, please do not hesitate to contact us.
Need help?
Do you have a question about the HANGBOARD and is the answer not in the manual?
Questions and answers