Download Print this page

Scott Aerator Night Glo Quick Start Manual

Led 2 and 4-light sets

Download this manual

WARNING: Bypassing the transformer will cause

the fixtures to fail. The transformer is an integral

and required part of the system.

Night Glo

LED 2 and 4-Light Sets

This Kit Includes

(2 or 4) LIGHTS WITH POWER CABLE

(2 or 4) 1/2" BOLTS AND NUTS

(2 or 4) STAINLESS STEEL ARMS

TRANSFORMER/CONTROL UNIT

Tools Needed

7/16" AND 1/2" WRENCHES AND PLIERS

Need help?

Do you have a question about the Night Glo and is the answer not in the manual?

Page 1 Night Glo LED 2 and 4-Light Sets This Kit Includes (2 or 4) LIGHTS WITH POWER CABLE (2 or 4) 1/2" BOLTS AND NUTS (2 or 4) STAINLESS STEEL ARMS TRANSFORMER/CONTROL UNIT Tools Needed WARNING: Bypassing the transformer will cause 7/16"...
Page 2 Note: Vary light Note: Be careful not angles to add a fuller to over-tighten the lighting effect. wire connection. It is designed to lock with 1/2 turn. Assembly Instructions 1. Attach each arm assembly to the water feature. Be sure to orient the arms with “L” facing upward. Remove one of the 2"...
Page 3 Back View 12 Volt Transformer Set-Up 1. Remove the screws in Post A and B on the back of the transformer. Post A and B 2. Reattach the screws to secure the two wires from the RGB lights. Note: It doesn’t matter which wire is attached to either post. 3.
Page 4 All other product components are warranted for one year from date of purchase. Scott Aerator will repair or replace failed parts under warranty when the defective unit is returned to the factory, shipping prepaid, and factory inspection establishes that the part was defective.