Lancaster Perforated Steel Can Assembly Instructions

Perforated Steel Can
A S S E M B LY I N S T R U C T I O N S
PARTS LIST:
Receptacle base
A
Receptacle top ring
B
HARDWARE:
(6) 6 mm x 20 mm
H
Phillips head screws
S T E P 1
On a firm, flat surface, position the first receptacle half
(C) so that its three pre-drilled holes line up with those
of the receptacle base (A). Insert a 6 mm x 20 mm
Phillips head screw (H) into each hole, using a hex nut
(J) to secure it on the other side. Hand tighten. Do not
tighten the screws completely in this step.
C
H
J
P E R F O R A T E D S T E E L C A N S • A S S E M B LY I N S T R U C T I O N S
(2) Receptacle halves
C
(6) 6 mm x 18 mm (12) 6 mm
I
J
Phillips head screws hex nuts
A
Liner
D
TOOLS REQUIRED:
• Phillips head screwdriver (not included)
• Wrench or heavy-duty pliers
(for lid; not included)
S T E P 2
Repeat Step 1 with the
remaining receptacle
half and the remaining
(3) 6 mm x 20 mm
Phillips head screws.
C
S T E P 3
Once both receptacle
halves are attached to the
receptacle base, adjust the
position of the receptacle
as needed and tighten all
of the screws around the
base of the trash can with a
screwdriver (not included).
W W W . L A N C A S T E R TA B L E A N D S E A T I N G . C O M
Flat lid or rain
E
bonnet lid
(2) Cable clips
F
Security cable
G