HSS Hire 49710 Operating & Safety Manual

The unit will pulsate in a controlled manner.
Double check that the waste water is being
dispersed to a suitable place.
Whichever you are using...
You must now put the headphones on and switch
the locator ON. The ON/OFF knob on the locator
is also the sensitivity control, turn the knob
clockwise to decrease sensitivity.
Hold the locator upright with the contact spike
touching the ground and listen for the pulse.
Work over the area in a grid like pattern, if
necessary, the contact spike can be immersed in shallow
water.
Cover the area until either a signal is located or
until you are fully satisfied that the area has been
adequately tested.
Close in on any sound and use the locators' dial to
display pulse strength.
Take extra care when wearing the headphones, as
you will not be able to hear anything around you.
EQUIPMENT CARE
Never push the equipment beyond its design
limits. If it is unsuitable for the task you are
performing DO NOT USE OR RELY ON IT. Contact
your local HSS Safe and Sure Depot for advice.
Keep the equipment clean - you will find this less of a
chore if you clean it regularly, rather than wait until the
end of the hire period.
Handle the equipment with care, avoid dropping or
knocking it.
When not in use, store the equipment somewhere
clean, dry and safe from thieves.
FINISHING OFF
Switch the locator OFF, disconnect
headphones then remove the contact spike and
place in its carry case.
Where applicable, switch the transmitter OFF and
disconnect any cables, or close off the main water
supply.
Have a qualified plumber remove the transonde
and restore the original pipe work.
Give everything a final clean, ready for return to
your local HSS Safe and Sure Depot.
Replacing The Batteries
To replace the locators' batteries, switch the unit
OFF , open the battery cover and unclip the
battery. Refit a new 9V PP3/MN 1604 alkaline
battery and replace the cover.
To replace the transmitter batteries switch the
unit OFF , pull out the red catches on either end
of the units' base. You can now lift the top clear
of the base. Remove the two battery tubes,
remove the batteries within and replace with 10
new 1.5V LR6 (AA) alkaline batteries. Refit the
battery tubes then the base and ensure the red
catches are correctly locked.
Dispose of the used battery in a responsible
manner.
Battery
Tube
Batteries
Contact your local
0845 608 8811
the
...any comments?
If you have any suggestions to enable us to improve
the information within this guide please fax your
comments or write to the Product Manager at the
address below
Fax: 020 8687 5001
©HSS Hire Service Group Plc 2000 No. SS017/01
Group Office: 25 Willow Lane, Mitcham, Surrey CR4 4TS
Web Site: http://www.hss.co.uk/safeandsure
Operating & Safety Guide SS017
Base
Plastic Pipe
Locator
Designed to locate non-metallic water
and waste pipes.
Code 49710