Aiphone PanTilt MY Series Installation & Operation Manual

83814600 0596®
® AlPHONE
MY Series
PanTilt VIDEO DOOR STATIONS
Models:
MY-EA
MY-FA
INSTALLATION & OPERATION MANUAL
SYSTEM OUTLINE & FEATURES-
MY-EA & MY-FA are semi-flush mount pan and tilt video door stations, which
can be used with any Aiphone MY video system (MY-1CD, MY-2CD, MY/IE,
MY/TD-H, MY/LEF).
PACKAGE CONTENTS
For 1 entry;
MY-ICD MY-CU
Connecting A1
Terminals
1A1, 1A2
MYW-P1L
A1, A2
FEATURES
• Audio, video, and PanTilt control on 2 wires
• Pan and tilting of door camera
• 100m, 330' from camera to monitor on 1.0mm dia.,
18AWG wire
• Extended distance to 300 m, 980' with MYW-BA adaptor
(using 1.2mm dia., 16AWG PE jacketed wire)
• Can replace an existing doorbell using the same wire
(remove existing transformer)
For 2 or max. 3 entries;
MY-2CD MYW-P3CB MYW-P3L
1A1, 1A2
2A1, 2A2
3A1, 3A2
1A1, 1A2
2A1,2A2
3A1, 3A2
' PanTilt video door station
(MY-EA or MY-FA)
»Tamper-proof screwdriver
• Packet of screws
• Installation & Operation Manual
LAYOUT EXAMPLE
MY-2CD MYH-2CD MYH-2CD
MY-DS
Refer to the Installation & Operation manual packed with
main monitor or adaptor.
NAMES AND FUNCTIONS
MY-FA
MY-EA
The MY-EA/FA, when measured at 50 cm, 20" from the camera,
views an area of 51 cm, 20" vertically by 72 cm, 29" horizontally.
On any and every inside monitor, operate Pan/tilt control pad to
maximize viewing area, and Backlight button to view dimly lit or
strongly backlit areas.
I
INSTALLATION & WIRING-
Wiring
Use 2-COnductor (parallel) cable.
Parallel conductor cable
Coaxial cable or 2 separate wires
should not be used.
YES
When existing chime wires are used, it is possible that the wires may
contain AC voltage current. Locate and remove the bell transformer
before actually connecting MY-EA/FA. . . .
Extra pair(s) in the installed cable can ^ ^ wires; ^
affect image quality, and must be ^
terminated with a 120 ohm resistor at [Bi| ai
each end of wires on both MY-EA/FA ^
and inside monitor(s).
Installation
MY-EA/FA employs a CCD
camera, and its performance can
be affected by bright direct light,
such as strong sunlight, gate light
or street or porch light which is
directed into the camera lens. Use
backlight button to compensate
for silhouetted images.
Strong
light
source
MY-EA,
MY-FA
MY-1CD,
etc.