Disc Operation; Disc Initialize; Disc Operation In Dvd±Rw Disc - Daewoo DF-4501P User Manual

What is DV?
DV model only
Using DV, also known as i.LINK, you can connect a DV-equipped camcorder to the DVD Recorder+VCR using a
single DV cable for input and output of audio, video, data and control signals.
The i.LINK interface is also known as IEEE 1394-1995.
"i.LINK" and the "i.LINK" logo are trademarks.
• The DVD Recorder+VCR is only compatible with DV-format (DVC-SD) camcorders. Digital satellite tuners
and Digital VHS video recorders are not compatible.
• You cannot connect more than one DV camcorder at a time to the DVD Recorder+VCR.
• You cannot control the DVD Recorder+VCR from external equipment connected via the DV IN jack (including
two DVD Recorders).
• It may not always be possible to control the connected camcorder via the DV IN jack.
• Audio input to the DV IN jack should be 32 or 48kHz (not 44.1kHz).
• Picture disturbance on the recording may occur if the source component pauses playback or plays an
unrecorded section of tape, or if the power fails in the source component, or if the DV cable becomes
disconnected.
46
Recording from an External Input

Disc Operation

Disc Operation

Disc Initialize

• If you load a blank DVD±R (±RW) disc, it will be initialized (formatted to enable recording).
• Do not start recording until disc initialization is complete.
• If you load a DVD±RW that has already been used you can record a program immediately.
Disc Operation in DVD±RW disc
For recordable DVD media, such as DVD±R and DVD±RW discs, you can manage the disc using the Disc Menu.
The DVD±RW Disc Menu allows you to erase, lock, or unlock your disc. You can also make it compatible with
most other DVD players.
At first, go to Disc Operation mode.
1
Press [SETUP]. The Setup menu appears.
2
While 'Disc Oper' is selected, press [ENTER] to go to the Disc
Operation page.
Erase the disc (DVD±RW)
3
Use [.../†] to select the 'Erase' menu.
4
If you want to erase the whole disc, press [ENTER].
5
To confirm, select 'OK'. To cancel, select 'Cancel'.
If you select 'OK' and press [ENTER], all the contents of the disc will
be lost.
Protect Disc (DVD±R, DVD±RW)
If you want to protect a disc from accidental recording, editing, or
erasing, you can lock the disc. Later, if you change your mind, you can
unprotect the disc.
3
Use [.../†] to select 'Protect' menu.
4
If you want to protect the whole disc, press [ENTER].
5
To confirm, select 'OK'. To cancel, select 'Cancel'.
If you select 'OK' and press [ENTER], all the contents of the disc will be protected.
DVD Recorder
Init Setup
Disc Operation
œ √
Select
Init Setup Disc Oper Disc Edit Timer REC
Erase
Finalize
Protect
Disc Operation
Make Comp
...† Select
Adapt
ENTER OK
Disc Info
DISC Exit
_
Exit
Erase
Erase this disc?
OK Cancel
Erase
Finalize
Protect
Disc Operation
Make Comp
...† Select
Adapt
ENTER OK
Disc Info
DISC Exit
_
Exit
Protect
Protect this disc?
OK Cancel
47