Summit SUM-900441 Manual

Summit SUM-900441 Manual

Rechargeable hot stapler kit

Advertisement

RECHARGEABLE
HOT STAPLER KIT
SUM-900441

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SUM-900441 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Summit SUM-900441

  • Page 1 RECHARGEABLE HOT STAPLER KIT SUM-900441...
  • Page 2: Safety Regulations

    RECHARGEABLE HOT STAPLER KIT Fig. 1 1) Heating Tube 2) LED Light 3) Switch Button 4) Toggle Switch 5) Type-C Charging Port 6) Charging Indicator 7) Plastic Welding Head 8) Special Soldering Tip 9) Plastic Welding Rods (ABS/PP/PE) 10) Staples (50) 0.03'' Corner Staples -Type V (50) 0.03'' Small Wave Staples (50) 0.03'' Large Wave Staples...
  • Page 3: Technical Data

    SPECIAL SAFETY INSTRUCTIONS FOR BATTERY AND CHARGER • If under extreme conditions any electrolyte should escape from the battery, it's essential to avoid contact with skin. If electrolyte does come into contact with your skin, rinse it off with water. In the event of electrolyte contact with your eyes, it's essential to consult a doctor.
  • Page 4: Using The Product

    Note! The plastic weld requires staples of the correct type . Use only the supplied and extra staples sold by SUMMIT RACING. • Remove any paint and other coatings and ensure that the surface of the part to be repaired is smooth.
  • Page 5: Troubleshooting

    Fig.3 THE WELDING ROD MUST BE OF THE SAME MATERIALS AS THE ITEM TO BE WELDED. Use Special Soldering Tip (Fig. 1) Attach the special soldering tip (8) install to the tip of the plastic welding head (7), press and hold the switch button (3) for 10-15 seconds until the soldering tip is hot enough to weld, Then tip feed tin.

Table of Contents