Advertisement
Quick Links
Advertisement
Related Manuals for SyberSense ClareOne CLR-C1-RCDW2
Summary of Contents for SyberSense ClareOne CLR-C1-RCDW2
- Page 1 CLR-C1-RCDW2 ClareOne Recessed Door Sensor Install Guide Version 240828-0100...
- Page 2 Installation Guide of Recessed Door/Window Sensor Recessed Door/Window Sensor The Recessed Door/Window Sensor Invisibly installed, it sits within a door/window and its frame to provide all the information needed by 433MHz system for security, safety, and ambiance. The recessed Door/window Sensor is comprised of two parts: the larger Main Sensor and the smaller Magnetic Sensor.
- Page 3 Installation Guide of Recessed Door/Window Sensor The installation of your Recessed Door/Window Sensor has two key steps: 1. Install both parts of recessed door/window sensor. 2. Connect recessed door/window sensor to the panel. Prepare the Main Sensor 1. Remove the Pull Tab to install the sensor. 2.
- Page 4 Installation Guide of Recessed Door/Window Sensor Change battery Please follow the below process. 1. Turn the lid of the sensor casing for pulling out the hardware from the plastic casing Latch 2. Pulling out the hardware from the plastic casing to change the battery. Version 240828-0100...
- Page 5 Installation Guide of Recessed Door/Window Sensor Install your Recessed Door/Window Sensor With Main Sensor powered and activated, it is now time to inlay it within your selected door/window frame. Before beginning, it is important to select a suitable position for your Recessed Door/Window Sensor.
- Page 6 Installation Guide of Recessed Door/Window Sensor Step 2 – Drill for Magnet piece. Drill a corresponding hole in your door/window. The hole should be 15mm deep. As stated, the position of this hole should align exactly with the hole you just created in the door/window frame. Again, use a 19mm wide drill bit.
- Page 7 Installation Guide of Recessed Door/Window Sensor Step 4 Place a small amount of white glue (PVA) inside the hole you created for Magnetic Sensor. Then, place the sensor over and into the hole. Next, insert it by tapping gently on it with a rubber hammer. Step 5 The gap between the two parts of your sensor must be no less than 1mm and no more than 5mm.
- Page 8 Installation Guide of Recessed Door/Window Sensor FCC Compliance Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Need help?
Do you have a question about the ClareOne CLR-C1-RCDW2 and is the answer not in the manual?
Questions and answers