Abbott Hyperion 1472g Quick Start Manual

Hyperion 1472g Barcode Scanner
Getting Started & Installation
The Edge allows users to optimize the store's efficiency by employing barcodes on nearly all records. Barcodes
are used on inventory items, POS receipts, tender cards, gift certificates, and job envelopes (repairs, appraisals,
layaways, and special orders).
Additionally, the Hyperion 1472g scanner supports 2D barcode scanning, allowing you to scan IDs and licenses.
This scanner can connect directly to the base via the USB hub, or for added convenience, can be used wirelessly
by pairing with your PC or tablet via Bluetooth.
2D scanning functionality requires additional setup as the Edge default scanner configuration is
NOT set for 2D scanning. Please see the Configuration section below for setup instructions.
Pairing the Device & Unlinking to Re-Pair Device
Pairing the Device – Scanner Base
Follow the steps below to pair your scanner to the included scanner base:
1. Plug the scanner into a working USB port.
2. Scan the barcode located on the bottom of the base.
3. Scan the programming codes, in order, in the section below labeled Programming the Barcode Scanner.
Pairing the Device Wirelessly – Tablet/PC
If you plan on using your device wirelessly on a tablet or PC workstation, you must follow the steps below to
first unlink the scanner from the base, then pair the scanner to your device of choice:
1. First you must Unlink from base:
a. Scan barcode:
If needed, a higher resolution image of this barcode can be found on Page 7 of the
Quick Start
6 May 2024
Guide.
©2024 Abbott Jewelry Systems, Inc.
HDW-2024-009
Honeywell
1