John JWM-10001 Instructions For Use Manual

Rehab buggy

Advertisement

Quick Links

for authorised dealer and user
John GmbH
Ziddelrasen 1b
D-99830 Treffurt
Telefon: +49 36923 8388-0
Telefax: +49 36923 8388-10
E-Mail: info@johngmbh.com
Internet: www.johngmbh.com
Rev: 01/01.2024
© John GmbH
Instructions for use
JOSI-Wismi
Rehab buggy
JWM-10001 size S
JWM-10002 size M
JWM-10003 size L
WE MANUFACTURE IN GERMANY
Overview Video
AL-JWM22-EN

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the JWM-10001 and is the answer not in the manual?

Questions and answers

Summary of Contents for John JWM-10001

  • Page 1 Instructions for use for authorised dealer and user JOSI-Wismi Rehab buggy JWM-10001 size S JWM-10002 size M JWM-10003 size L Overview Video John GmbH Ziddelrasen 1b D-99830 Treffurt Telefon: +49 36923 8388-0 Telefax: +49 36923 8388-10 E-Mail: info@johngmbh.com Internet: www.johngmbh.com WE MANUFACTURE IN GERMANY Rev: 01/01.2024...
  • Page 2: Table Of Contents

    Useful life and long-term durability ....................20 Re-use ............................21 Disposal ............................21 Guarantee ............................. 21 Reporting serious incidents ......................21 Technical data ..........................21 27.1 Materials used ............................. 21 27.2 Measurements ............................ 22 27.3 Product label ............................22 © John GmbH page 2/23...
  • Page 3: Introduction

    4. CE-conformity John GmbH, as manufacturer, declares under its sole responsibility that the JOSI-Wismi is a medical device in compliance with the applicable requirements of Regulation (EU) 2017/745 of the European Parliament and of the Council.
  • Page 4: Additionally When Used As A Bike Trailer

    AMF Transit Tie-Downs, hip belt and additional stand. In the vehicle, be sure to use the integrated hip belt of the fastening kit, the inclined belt fitted in the vehicle and a wheelchair restraint system approved according to ISO 10542. © John GmbH page 4/23...
  • Page 5: Building Up Josi-Wismi

    Check that the quick release axle is correctly fitted. It must not be possible to remove the rear wheel without pressing the release. 3) Mounting the front wheel or bike drawbar See chapter Front wheel and adapter. © John GmbH page 5/23...
  • Page 6 Fold out the sun canopy. 8) Adjusting the push handle Use the quick-release to release the ergonomic push handle. 9) Covering the folding mechanism Use the pushbuttons to close the covers for the folding mechanism. © John GmbH page 6/23...
  • Page 7: Front Wheel And Adapter

    12,5“ off-road wheel 8“ swivel wheel Bike drawbar 12,5” pro-wheel with locking function Locking function: Press the red button E to switch on the locking function. Pull the black lever F to switch on the swivel function: © John GmbH page 7/23...
  • Page 8: Folding Josi-Wismi

    Fold in the back and lock the two quick-releases. 5) Folding in the back frame The back frame can be folded in by unlocking the quick release on both sides. © John GmbH page 8/23...
  • Page 9: Anti-Tip And Tilting Support

    Attention! An incorrectly adjusted centre of gravity can have a negative impact on driving behaviour. Tipping backwards due to an incorrectly adjusted centre of gravity has to be avoided. © John GmbH page 9/23...
  • Page 10: Seat System

    Do not move the tilt-in-space at the upper back, but at the rear seat bracket (A). 2) Moving seat unit in right position Move the seat unit into the right position. Tighten the lock again. © John GmbH page 10/23...
  • Page 11: Back & Seatposition Belts

    Headrest (shell-shaped or V-form, adjustable via velcro) Thoracic pads (adjustable) incl. back cushion Abduction wedge (adjustable) Anatomically adjustable seat cushion with tuber edge Side guide or pelvic support (adjustable) Footrest, basic configuration (adjustable via velcro) © John GmbH page 11/23...
  • Page 12 If needed, the foam can be removed completely. 6) Back cushion The back cushion has a variable height. Fold the back cushion backwards on the upper side at the desired height and velcro it on the inside. © John GmbH page 12/23...
  • Page 13: Belts

    Adjust the belt system so that it fits close to the body and provides sufficient support. At the same time, make sure that the straps are fastened in such a way that the user can breathe freely. © John GmbH page 13/23...
  • Page 14: Belt Height

    Turn the belt back through the fitting opening. Please note: If the slots don´t exist yet they need to be cut out by a sharp knife. Attention! Only cut at the designated points to avoid tearing. © John GmbH page 14/23...
  • Page 15: Belt Length

    Please note: When the belt is adjusted to the desired length, pull the belt buckles (front) to tighten the belt. 4) Back cover and bag Close the back cover and add the bag again. © John GmbH page 15/23...
  • Page 16: Brake And Parking Brake

    Extension for sun canopy  Mosquito net  Rain cover 18.2 Extension for sun canopy 1) Extension for the sun canopy The extension can be attached to one of the two zips on the sun. © John GmbH page 16/23...
  • Page 17: Mosquito Net & Rain Cover

    4) Front attachment Place the mosquito net or the rain cover over the front of the frame and put the rubber band around the pulling lock of the front wheel / bike drawbar. © John GmbH page 17/23...
  • Page 18: Bike Drawbar

    Read the Installation Instructions for the Weber coupling and strictly obey them. 4) Fasten the safety line Connect the safety line using the mounted belt strap. Attention! Pass the belt trap through the frame of JOSI- Wismi. © John GmbH page 18/23...
  • Page 19: Combination With Other Medical Devices

    For the operating instructions and guarantee conditions, please observe the enclosed manual for the Decon E-Drive! It is recommended to have the installation carried out by the manufacturer (John GmbH). The installation must be carried out by a specialist. © John GmbH...
  • Page 20: Care And Maintenance

    UV radiation  humidity  dirt  temperature  salty air  contact with salt water  roads strewn with salt  storage  the state of maintenance  maintenance and inspection work © John GmbH page 20/23...
  • Page 21: Re-Use

    3 years on the aluminium frame 26. Reporting serious incidents All serious incidents occurring in connection with the products must be reported to the manufacturer (John GmbH) and the competent authority. „Serious incident“ means any incident that directly or indirectly led, might have led or might lead to any of the following: the death of a patient, user or other person;...
  • Page 22: Measurements

    The weather-resistant product label of the JOSI-Wismi is located on the rear wheel axle. If the product label is no longer readable, be sure to contact your specialist dealer so that a new type label can be requested from the manufacturer. © John GmbH page 22/23...
  • Page 23 John GmbH Ziddelrasen 1b - D-99830 Treffurt - Tel: +49 36923 8388-0 - Fax: +49 36923 8388-10 - info@johngmbh.com © John GmbH page 23/23...

This manual is also suitable for:

Josi-wismiJwm-10002Jwm-10003

Table of Contents