Before Using For The First Time; Starting An Empty Washing Cycle - Siemens WM14N29XDN User Manual And Installation Instructions

en Before using for the first time
Use a WAF 17 wrench to tighten
3.
the lock nuts against the housing
until they are hand-tight.
In doing so, hold the foot tight and
do not adjust its height.

Before using for the first time

5 Before using for the
first time
Prepare the appliance for use.
Before using for the first time
5.1 Starting an empty wash-
ing cycle
Your appliance was inspected thor-
oughly before leaving the factory. To
remove any residual water, run the
first wash cycle without any laundry.
Turn the programme selector to
1.
Tromlerengøring (Drum Clean).
Close the door.
2.
Pull out the detergent drawer.
3.
16
Pour approx. 1 litre of tap water
4.
into compartment II.
Add washing powder containing
5.
oxygen bleach to compartment II.
To prevent foaming, use only half
of the amount of detergent recom-
mended by the detergent manufac-
turer for light soiling. Do not use
detergent suitable for woollens or
delicates.
Push in the detergent drawer.
6.
Press ⁠ to start the programme.
7.
The display shows the remaining
a
programme duration.
After the programme has ended,
a
the display shows: "End" .
Start the first wash cycle or set the
8.
programme selector to Fra
to switch off the appliance.
→ "Basic operation", Page 27
⁠ (Off)